Owner reviews for brake discs

@tbomb, that's old school thinking. You can easily change the gapping, just don't be retarded and slam a coin or something in there and start bashing away. lol

While I understand the need to be frugel, you're talking about the most important safety equipment on your car. IMO this is where you don't cheap out. I just bought a set of Zimmerman replacement rotors (fronts) and a set of PBR Deluxe pads for under $200. Like the old Fram advert said... 'you can pay me now, or pay me later'.

we did an AutoX last month and i even had the better times. they arent all they are cracked up to be.

I've had Meyle Corrado G60 11.0" 4-bolt rotors on my 97 Jetta GT for two years, and they are barely wearing (plating is gone off the friction surface of course, but holding up well over the rest of the rotors).

I have since upgraded to oem rs2 brake brackets with porsche 996 calipers and audi s8 rotors, everything was bolt on with good clearances.

Zimmerman front rotors with ebc pads. Stainless braided brake lines on all four corners and ate super blue brake fluid.

I'm kinda partial to Meyle plated rotors. They're inexpensive, high quality, and appear to be wearing well on my 97 Jetta GT (Corrodo G60 11.0" front calipers and rotors).

I had the car in at the dealer on Saturday morning. Spent about 3 hours there. The service guy took it and had the front rotors replaced. They agreed there was quite a bit of shake in the steering wheel. All in all, good experience.

I have the zimmermans, and I've heard numerous people tell me they've seen and heard of them cracking under heavy heated use. It kinda worries me a little, but they've been solid so far, and I've yet to really roast them... Honnestly if I were to do it again, I would probably go with the brembos even though they may be a little more expensive. whats more important to stopping, is pads. The difference between the stopping power and feel of different pads varries greatly. I've had some heavy carbon kevlar pads that took a long while to warm up but once they were warm grabbed really well, but they were kinda hard for regular street driving. I've used stock pads which pretty much suck but last forever, and I've used some softer sport street pads that wear and dust a little more, but stop far supperior to oters for regular street driving. I've yet to push them to the point of fade, but we'll see where that goes once I've got the suspension and bleeding sorted

Unfortunately the problem is inherent in the design of the rotors. Not in where they were produced. You can put the best rotors in the world on that car and they will still warp. Vw/Chrysler would need to spec a larger and thicker rotor to help dissipate heat properly. All aftermarkets will make the rotor to fit, based on the crappy oem specs. So, get used to having new rotors put on...because recall or not, Chrysler still needs to redesign that rotor. FYI, I'm in the same boat as you guys! These rotors suck!