Chevrolet parts reviews

I'm running 4600's on my blazer and they've been great.

In Sept/Oct I had a new denso fuel pump put in. Denso fuel pump. Problem is fixed. I’ve been driving the truck like normal for months now. Happy to say this is solved.

I just replaced struts all around my monte with moog very happy with them.

seattle-ish area here, BFG K02s on my colorado. previously had 2 sets on an older land rover. no ragrets. snow, rain, you name it. they even did ok in some standing water.

I use K&N filters on 3 of my vehicles - my '74 G30 350 V8 Chevy Van tow vehicle, my '93 RX-7, and my F2000 racecar. On the racecar, it is a required spec part required for all F2000 cars using the Zetec engine. In 14 race seasons (~100 races) of use it has caused no issues. My engine builder says my engine always looks good when they get it for a refresh. On the RX-7, it was part of an induction upgrade (the OE intake was very restrictive) and provided a noticeable power increase. It has caused no issues in the ~60K miles it's been in use. On the Chevy van, the OE air cleaner was way too small and restrictive for towing purposes. The K&N provided a significant benefit in gas mileage and power. It has been in use for ~200K miles and has caused no issues. YMMV.

I was on the hunt for a facelift LT1 car and specifically went after a 95 for the stock bigger brakes and a few other things. I am extremely happy with my purchase and highly recommend.

Bosch Evolutions for my winter weather

Thats not a VW problem, that a cheap/faulty brake rotor problem. The only car I ever owned that would not shake when braking hard over 70 mph was my 2014 cruze with fresh power stop rotors and pads.

Had Uniroyal tiger paws on my s10 - worst handling tires ive had on snow. Wore like rocks tho.

I have a 1986 blazer and replaced the spark plugs with ac delco factory spark plugs purchased from napa, about 2 months later I was driving the vehicle and the vehicle had a miss then starting blowing out oil from the Pcv vlave from excessively high crank case pressure after electrode fell out.