Mazda parts reviews

Try, Federal RS-R. It should be equal to XS in performance but cheaper. I have the 195/50/15 on Miata and I think it is better than my previous Falken Azenis.

On a positive note- the brakes were sporty car firm and easy to modulate even with these tires.

The wheels look absolutely great and they drive great, the driving feel with such a light wheel is amazing. One of the wheels wasn’t perfectly round and had a small hop to it... I put 1500 miles on them and the vibration never bugged me, even on a road trip to Chicago.

I had the WS-50 on my Miata (came with it) and they were fanfukintastic in snow and ice but lasted about 20,000 miles total before turning into slippy dangerous banana peels while still showing 6/32 remaining.

AAS (Auto Adjusting Suspension) 3 stage adjustable shocks with motor on top that adjusts damping. Super simple reliable system. OEM Front shocks on my car lasted til 300k km. Rear shocks lasted til 240k.

my 195/55/15 direzza's lasted last summer. approximately 7k, with over 40 autox runs, and 4 hot laps at a local track. they were about 50% remaining tread. keep in mind they were on a miata.

I ran the Kumho XS (250/50 15 on a 2006 Mazda 2) last summer and found them to be fairly comparable to the superceded Bridgestone RE01R, albeit much cheaper. I did 4-5 autocross sessions on them on top of 'spirited' drives in the local mountains every weekend. My fronts lasted just under 3000 miles to slick and the rears around double that, but I do have a fairly aggressive alignment.

Sorry if my comments offended you. With the Toyo T1-S, I've run 195/55R14's on both a Miata and a Rabbit GTI. I've used 3 different wheel sizes with those tires (and I've had two sets over the years). On 5.5" wheels (stock Miata wheels), they are a little too vague on turn in for my taste. But they have gobs of grip once you get it turned in. On 6" wheels, they are a bit sharper, and the grip is about the same as on the 5.5" wheels. On 7" wheels, they get even sharper, but seem a little harsh, and they have noticeably less grip for cornering and for braking. And when they get to the limit on that wheel, they tend to let go a little abruptly. I've also seen some lap time test results for other sizes of the T1-S (Speed Touring and GT cars ran those tires a few years ago), and it was pretty consistent. At the widest end of the recommended wheel widths, they were already losing a significant amount of grip and were very unforgiving. They seemed to perform best toward the middle of the specified range of rim widths.

So I went with the OEM clutch manufacturer, Exedy. I purchased what I thought would be an upgraded clutch, the EXEDY 10803AHD Clutch Kit. The dealership installed the new clutch without issue and without addition labor charge at that time. That was less than 10k miles ago. The dealer finishes the inspection and informs me that the clutch its self has failed. I called Exedy and talked with a technician. After explaining the situation and providing him the part number for the clutch, he promptly informed me that they no longer recommend that clutch to RX8 owners, only FC RX7 owners. Within the last three months they discovered that the tolerances were off by 1 or 2mm, causing premature failure. The kicker is that I didn't originally buy the wrong clutch. It was one they recommended for the 8 at the time I purchased it. Even though they agree with that statement, they refused to do anything for me with this issue its caused. Absolutely zero. Its just absolutely shocking to me that a well known company like them would operate that way.

I'm surprised Mazda is rated so poorly, I had a Mazda MPV for 8 years and honestly the only problem I had was the driver's side window gear was worn out, and the alternator.