Mazda 6 parts reviews

Buy a set of PowerStops and call it a day.

I’ve done this on both my 6s and never looked back.

Switch to powerstops and you are set for the next 50k miles (depending on your driving style/conditions). My OEM rotors warped around 16k miles, dealer resurfaced and it warped again at 20 something. Replaced with another new set of OEM rotors which too warped before my car hit 30k miles. I followed other lads on mazda6club forum and switched to Powerstops and it is still going strong at 62k miles.

Akebono have been better for my 6 than the OEM. OEM pads are not all the same. They may meet the same minimum spec but not all are top tier. For example the rear brake pads on my 6 OEM were great and were made by TRW. the last set of OEM rear pads were from another manufacturer and are dusty and wear fast. My recent front OEM pads are the same. I'm going back to Akebono pads when the weather is better

I recently installed Brembo rotors and pads on my ‘14 Mazda 6. Under $400 on tire rack. The performance is great so far; they bite harder than OEM and are quiet with low dust.

Peak Asian green coolant works fine. I used it last week and my Mazda 6 is working fine

2018 Mazda 6 is going fine.\n\nProbably due for a battery soon as preventative maintenance.

IMO, best bang for your buck is Fram XG6607.

Michelin Pilot Sport A/S 3+'s, MUCH better than the Falkens that came with the car.

I run the ATR sport on my 2018 6 GT, only issue i had was it made the car feel like it had a lot of body roll, I think the ATR tires have more grip then the stock suv Falcons that came stock.

Mazda. Brakes. Suck. I’ve owned 2 6s. A 2018 and a 2021. Both needed brakes at around 20k. DO NOT REPLACE WITH MAZDA OE BRAKES. Or you’ll just be in the same boat again. Buy a set of PowerStops and be done with it.