Honda parts reviews

I have the same type of tires on my 16'. They have been so much better than stock Firestones

Here are my initial impressions:

Pros:

a) Quieter than the Dunlop Super Sport 7000s that come stock. This could be because my stock tires were showing some surficial cracks in the rubber, although this complaint is normal. The stock tires crap out within 50,000 km anyhow.

e) Good rain performance...no issue with braking during rainfall on these tires.

Cons:

a) Sizing of the stock tires means that the tires will follow the downslope direction of the road crown, even if it's a minor one (this is partially due to the short wheelbase and hyper sensitive steering rack). I got my tires aligned after the install, before the alignment brigade chimes in.

Overall, I am very happy with the tires. They work as advertised and didn't tear a hole in a my wallet. They are a valid option for those seeking new tires for the Fit.

I run Rotella T6 5w-40 full syn Heavy duty Diesel engine oil in all my small engines with good results. Scooter, ATV, lawn mower, Honda car, and my F350.

A few months ago, at 16+ years old, it got front struts since they were leaking and starting to make noise.

Hawk HPS Pads

Mobil 1 full synth, or castrol full here as well, and usually their filters.. Yearly oil changes for me by my driving, and I change the filter every oil change instead of every other

Mechanic said he'd replace the oil filter, maybe sometimes that problem is caused by non Honda oil filters. I said ok.

Lo and behold, the CC drifting problem is gone, but fuel efficiency is down to about 24 highway. No limp mode or other problems.

For instance, on my Honda Fit, I went aftermarket on the brake rotors because the factory ones had a habit of warping with my driving.

A gates timing belt kit for a Honda will have OE parts as Gates is a OE supplier for Honda. Except for the water pump./ Gates water pump are garbage so NEVER use a gates water pump if its driven by the timing belt.

The oil filter on my Civic. It's located behind the engine block, and the only problem is that my hands and arms are too big to reach it :(