Brake discs Brembo or Raybestos

Cost me $260 (parts and labor) to have the 4 Brembo rotors installed and the brakes are working great again. I think I am partially to blame for not bedding the pads properly.

I have their drilled discs on my TR6. My dream was Ceriani, forks with disc brakes, I still have a new brembo caliper. They are and were a status item.

I’m running Raybestos rotors (good warranty and price) with Stoptech Sport pads and I like the brakes quite a bit.

For daily use, go for brembo blanks on your rotors. Oem pads are great for that initial bite but HORRIBLE on dust. I would go for akebono ceramic pads. They need a little more time to be warmed up but they’re great imo. Hardly any dust, super quiet, and they do just fine on my occasional canyon runs.

I priced out parts at $201 + S&H for premium raybestos rotors and pads at all 4 corners for a 2012 outback 2.5l on rockauto. Will be better than new for less than half the price.

I put Brembo Sport rotors with EBC Red Stuff pads and ATE TYP200 brake fluid. Works great.

Got these on my Corolla, they're actually good for reasonably cheap brakes.

i was on the fence about buying them and i did a bunch of research and after speaking with my buddy who is a mechanic and owns a tundra he said that the powerstop brakes aren't great and if you don't have the money to do the tundra swap, to get the brembo rotors and either akebono or brembo pads. ive been driving with this setup for about six months and have had no issues. the braking feel and stopping power has noticeably improved.

I know my Brembos cracked like a Mofo. They are still kicking ass and unwarped though

The front rotors were in a box from Zimmerman and rear were from Brembo. Just about from the start the brakes slightly squealed. The noise gradually increased that nearly each time the brakes were stepped on they squealed. After about 2K miles the noise got to the point of being excessive. They squeal in the morning when cool when slowing from 20MPH or warm and hot when slowing from 45+MPH. The only way to make them silent is to slam on them hard, but the next time they will squeal as well. In addition to the noise, the rotors started developing rust on the hub sections.