Spark plug NGK or OEM Mazda

I went to the dyno today and ended up with some pretty good #'s 321HP 304TQ Car was ran on SPS3 settings boost 9 timing 9 with Sunoco gt100 fuel. Temperature was mid 70's My car: 2003 A4 1.8t quattro ATP/Revo GTRS ATP Manifold Ecode Front Mount Intercooler Ecode Test Pipe Neuspeed Xtreme Turbo intake pipe Neuspeed Exhaust Stock airbox with K&N panel filter stock N75 valve working And NGK BKR7E plugs South Bend OFE SS clutch I could have done better if I had the right plugs (Bosch 3 electrode) and a manual boost controller but im pretty happy overall. Also the car was pulling 0 correction factors all the way through the rpm range so Lemmiwinks could have helped me with some more timing.

I run ngk bkr7e plugs gapped to .024 at 15psi. No probs here.

I have been runing the NGK BKR7E which is one step colder than stock (NGK Part# 6097) and I have a K04 with GIAC K04 software and other mods. They work great with a .028 gap. I change my plugs every 5K.

I just installed some of these NGK (BKR6E) plugs. I set the gap to .030 These went my 99 A4 1.8T Avant Quattro. The car is stock except for a K&N filter. Idle seems awesome and flawless all the way through the rev range.

I use them, but a colder plug, they work great.

Yes the 5's are colder plug But they run great and less fouling out.

I just put in NGKs today and it fired right up.

I'm running NGK BKR7E plugs, gapped to 0.028 with APR's K04 program and its working fine.

There was a considerable difference when I installed my new NGK plugs. My engine revved up easier and the fuel efficiency increased.

I put in a set of BP6ES today, gapped to .022", and had every bit the misfiring problems as before, and probably a bit more severe and more frequent.