Brake pads Ferodo or Raybestos

I recently replaced my factory Kia front pads with some EHT's. Did not replace rotors, just cleaned and removed some rust on them. Applied some caliper grease to the proper areas and these pads so far have been really nice. A VERY noticeable difference vs. the factory pads in stopping power. My only complaint was that Raybestos did not include new pad retainer springs in the box.

I'm running Ferodo DS 1.11. and they're fine on the streets even during winters when it gets even as cold as -25C

Guy above says don’t go cheap….I just used some raybestos pads and rotors for the rear I got from rock auto for 100$. Cheap, fast and easy. First time doing brakes and despite some snags had it done in an hour.

Fitted my 2017 with new front/rear brakes and rotors yesterday. I went with the daily driver level Raybestos brand kit from Rockauto. Included both pads and rotors with hardware. Did the work myself. While I obviously can't say anything about longevity yet, performance seems good so far. Especially for the price when compared to over double for Duralast from my local AutoZone.

I got their vented rear and front rotors (Girodiscs) with stock calipers and Ferrodo DS2500 pads all around. For a stock powered car they work great at VIR. I have done 2 sessions there now and braking is pretty decent. On the street this combo will never fade period. The rears overheat which overload the fronts and cause issues. Rears overheating also causes the wheel bearings to go out so getting vented rears is just smart.

Ferodo DS2500 are a classic high performance street pad, every time I go through a set I am sure something better must have come along and do some market research, always end up back on the DS2500´s as an everday/occasional track pad. They are cheap and they last forever (really) relative to punishment taken, they are dusty though, that´s really my main issue with them.

If you can't find ceramic pads, get Ferodo Premium Eco Friction.

DS2500s on my daily. Bit of squeak, but it’s not bad at all. I have EBC yellow on the rear as they don’t make DS2500s for a non PP mk7.5, and they’re garbage.

I replaced the pads and rotors on my Jetta this past spring. I put on Raybestos Element3 pads and coated rotors, and I've put maybe 6k-ish miles on them since then. Everything was fine for a while, but lately a squeal started to slowly develop until now it's every time I use the brakes. It sounds exactly the wear indicator noise I'm used to hearing when pads are low.

I had a track day today with 1 hour session and closer to the end they were fade.When I took the pads out to check I noticed that they are extremely glazed like covered with a melted metal.Also, looks like they covered rotors with this melted metal, the inner side of both of them.The outer rotors surface is fine. The outer pads look the same glazed.I was checking them yesterday last time and they looked fine.The friction material looked fine and not that glazed.It's on the last photo.I was trying to brake short and strong all the time.There car is Suzuki swift sport.Brake pads ferodo dsuno.Track Zolder.