Brake pads EBC or POWER STOP

EBC Brake pads
the1986Nirvana
  • Braking:
  • Dust:
Rating 4.5

Used these all last season for autocross and track and they performed great, no noticeable fade and bites hard, dust was significantly more than stock though imho

Pros: great performance, no fade, bites hard
Cons: lots of dust
Comment
Is this review helpful?
source
POWER STOP Brake pads
imitkov17
  • Braking:
Rating 4.5

I too use PowerStops in my 2015 Mazda 3 s GT and 2017 CX-9 GT. Second set in my Mazda 3. They are superior to the OEM and cost ~$200 + tax for both axels including pads, rotors, all hardware and lubricant. Surfacing the old rotors is not worth it.

Pros: superior to OEM, easy job
Cons: OEM inferior
Vehicle: Mazda 3
Comment
Is this review helpful?
source
EBC Brake pads
PJH87
  • Braking:
Rating 5.0

I run EBC Yellow on stock discs. Car is used for spirited drives and the Nurburgring. No complaints in 10+ years of use

Pros: no complaints, long lasting
Comment
Is this review helpful?
source
EBC Brake pads

I've been using EBC Yellowstuff pads for a while and they've been great. My car gets used hard on the road, and occasionally on track. They don't last as long as standard pads, but worth it for the extra stopping power!

Pros: great stopping power
Cons: don't last long
Comment
Is this review helpful?
source
EBC Brake pads
yatogamii
  • Braking:
Rating 5.0

Have had them for a year or two now. Do the proper break-in procedure and they're a nice upgrade over stock. Honestly don't think anyone needs more for the streets

Pros: nice upgrade, good for streets
Vehicle: Subaru
Comment
Is this review helpful?
source
EBC Brake pads

I did the Yellowstuff pads and ebc rotors on the back of my ‘17 RS. The one spring on the drivers side didn’t seat properly at first and squealed until I disassembled it and put it in properly.

Cons: squealing
Comment
Is this review helpful?
source
1 ... 76 77 78 79 80 81 82 83 84 ... 113

Write your review

Help others - share your experience with this part.

Other comparisons
Loading...