Brake pads EBC or OEM Mercedes

I've ran 2 seasons in a 3300lb Golf R with SR21 fronts and SR11 rears and they've been insane, in my humble opinion. One front set lasted 10+ events, with street miles in-between, and the rears are still the same originals I slapped in 2 years ago. Zero fade, crazy long life, and no chunking/glazing/side effects I can think of. Ran DTCs in the past, and I'd snag these in a heartbeat over any other pad I've used or seen firsthand. The only complaints I have is they bite HARD. Since these work from ambient they will throw you through the dash in the paddock if you aren't careful ???? The plus to that is no real warm-up laps needed. Sintered also stands up to heat extremely well since there is no resin to break-down, which means I can run titanium shims without it baking the pads. Outside that, they throw off some weird non-ferrous silvery dust. Nothing like most race pads where it'll cake everything in the wheel well. It's almost like a bit of gravel dust after every event. Then the price, depending on your pad shape. They're a little under $100 more than most pads in my case, but the life of them more than makes up for it.

I used EBC blue stuff on my BRZ with factory brembos, and replaced the pads using FCP euro lifetime warranty. EBC blues would hold up for multiple track days with stock power on 200TW tires, and I didn’t experience fade at my skill level, usually intermediate at HDPE days.

I have a dedicated track car but I use it to have fun. Therefore, I'm going to test out EBC Bluestuff NDX pads to start this season. I've also used PowerStop Track Day pads and they felt great.

I did dot 4 fluid, braided lines, new solid rotors, and EBC yellows and couldn’t be happier. Brake fade was VERY much improved.

I've used EBC Yellowstuff and Intima race/track pads for the i30N from Australia...both were fine, but I liked the factory Hyundai pads better.

I got the bluestuff pads for the front of my car and couldn’t find the bluestuff rears in stock anywhere so got another brand for there. From what I heard it’s a solid brand

Ebc redstuff and dba rotors are what I’m running and I love them

The pads work great, no fade for me at my skill level, even with a 40 minute session. Also work great on the street, with no noise or issues cold. However, I am using up about 70% of the pad in 2 hours of track driving. Particularly the rear pads, which are wearing noticeably quicker than the fronts.

Be careful when buying brakes for the Stinger, if you buy anything cheaper than the originals you'll get a nasty judder within a couple thousand miles! I had to replace the disc and pads with EBC Yellow to get rid of it. The judder was awful.

I have personally ran these rotors with EBC HH pads. I blued them on my first track day and swapped to used OEMs before the next. They felt fine as far as bite but the immediate bluing shows they’re not up to any amount of real heat. If I ran them for a track day or two more they surely would’ve faded badly and warped. I don’t recommend them.