Brake pads Brembo or Hawk Performance

I’m a fan of the Hawk HP+ track pads! The bite and fade resistance is excellent. They’re a little squeaky on the street but not terrible.

For last Autox season I used the factory calipers. Hawk blue pads, motul brake fluid. Had no issues at all.

You can save on the brake pad prices, either buy the original parts from a shop in sharjah for much less or install Brembo Brake pads which also cost much less and are also very good quality.

I autocross a bit and went with Hawk rotors and pads from Tirerack after a bit of mulling it over. Overall fairly happy with them, a little dusty but have NEVER faded while on them hard. Put maybe a hard 5k miles on them so far.

edit- I do have a 1.8 and as mentioned at least once you should consider getting the 1.8's calipers.

I run hawk hps pads on my NA. They've held up to entry level track work and not made much noise on the street. Feel fine when I choose to drive the Miata to work.

I swapped front pads with a 13mm socket, hammer and drift pin. In about 30 mins in my driveway. $210, parts delivered from Amazon. Took the opportunity to scrub out calibers free from all the caked on brake dust. Cleaned the inside of the wheels while I was there. Dealership wanted $787 just for the front pads and quoted more than $1000 installed. Easiest job ever and saved $500-$700.

If you DIY and have the tools I did front and rear brakes on my 340i with brembos for $725ish

I have 45k miles on my 2016 STI and just replaced all 4 rotors and pads with another set of Brembos. I don’t drive the car particularly hard and probably could have waited a bit longer but they are done now so I shouldn’t have to worry about them. Cost me about 1k all-in, parts and labor.

I recently did the Hawk 5.0 pads and they are lacking on initial bite. Bit disappointing. Much better for repeated breaking tho, as they warm up.

I ran Hawk DTC60's for one event. They dust like crazy which isn't the end of the world by itself, but if the dust touches any moisture at all (like the rainy track day) it mixes into what I can only describe as ferrous concrete. So not only is the dust-crete impossible to remove by any normal means, it then rusts like crazy, turning whatever wheels you have into a runny orange mess. I tried multiple different wheel cleaners, multiple brushes, soaking, anything and nothing could get it off. I had to use scotch brite and scuff the hell out of the wheels to get it off. Fortunately I run cheap TRM wheels and it's a track-only car otherwise I would have been livid.