Control arm

Owner reviews for control arm

Manufacturers
RTS Control arm

This kit features OE quality components, all made in Spain by RTS, and represents an excellent value. These components are critical to safety, and we don't feel the risk of questionable parts is worth trying to save a few bucks.

Pros: OE quality components, excellent value
Cons: risk of questionable parts
Comment
Is this review helpful?
source
OEM Volkswagen Control arm
Jorgsphaeton
  • Clunks:
  • Stability:
Rating 5.0

I had the same problem: this is what I had done: replaced rotors and brakepads, short time result replaced the wheelbearings and hubs, and new rotors again, shudder almost gone, only noticable on very flat roads and only on some speeds replaced all the control arms and that solved the whole problem.

Pros: control arms solved problem
Cons: short time result
Comment
Is this review helpful?
source
Optimal Control arm
stevegmu
  • Stability:
Rating 4.0

Everything I have purchased from Optimal- lower front control arms, lower ball joints and tie-rod ends were stamped made in Germany on the parts themselves. Seem very high quality compared to others I was considering.

Pros: high quality
Comment
Is this review helpful?
source
OEM Volkswagen Control arm
Triumph
  • Clunks:
Rating 4.0

My B5 Passat was essentially the same car as a FWD A4. Had lots of trials and tribulations with that vehicle, but when I sold it with 110,000 miles, it looked and drove like new. I think I had a good example, but the only thing "major" I had go wrong was the control arm clunk, so I replaced all of those.

Pros: drove like new
Cons: control arm clunk
Vehicle: Volkswagen Passat B5
Mileage: 177028 km
Comment
Is this review helpful?
source
MEYLE Control arm
mgyip
  • Clunks:
  • Stability:
Rating 5.0

I've used them (control arms, ball joints, strut mounts (only on street cars), wheel bearings, etc) for years without any problems. Granted I only log about 3000 miles/year on one of the cars but it takes a fair share of abuse during those miles and I haven't yet broken a ball joint or a tie-rod end.

Pros: no problems for years
Mileage: 3000 km
Comment
Is this review helpful?
source
MOOG Control arm
zero.
  • Stability:
Rating 1.0

I think RockAuto has bad batches of these. Received a replacement that was worse than the first one and welded crooked. Same problem with subframe interference and not being able to line the back side up to thread the bolt in. Sent both back for refund. Picked up an OEM control arm from GAP and it installed without issue.

Cons: welded crooked, subframe interference
Comment
Is this review helpful?
source
OEM Audi Control arm
slomofo.
  • Clunks:
  • Stability:
Rating 2.0

Audis are fun to drive and own, when you're not installing new control arms, valve cover gaskets, tensioner gaskets, timing belts..... Audis suck to maintain.

Pros: fun to drive and own
Cons: suck to maintain
Vehicle: Audi A8
Comment
Is this review helpful?
source
1 ... 6 7 8 9 10 11 12 13 14

Write your review about control arm

Help others - share your experience with this part.

Loading...