Spark plug Bosch or OEM BMW

Today I installed new spark plugs and the misfiring situation has improved significantly but is not completely gone. If I pull up the RPM too quickly the misfire counter goes up.

I just replaced my oem densos with some Bosch plugs that were labelled as being pregapped 1.1mm. I wanted them to be 1mm and checked with a gauge and Lo and behold they were already at 1mm. Whacked them in and improved my fuel consumption immediately.

I took it back in after setting the DPR to 2.5± 2.5 mA, checking again for any vacuum leaks, tightening down all the exhaust components, and changing out the spark plugs (again). I also checked the O2 sensor, it was fluctuating between .1v-.7v continuously.

To be honest the last plug VW went with , the 101905601F (OEM clones Bosch copper nickel FR7HE02 Or NGK ZFR6T-11G (5960) Copper Nickel, Beru BRU-Z272 copper nickel ) for the 2.5 is best. It’s one shade cooler and will have less spark knock. You have more timing.

I ended up leaving them as is and the car seems to be working fine.

Just got a Jetta again - 2010 Limited Edition just shy of 100K miles and I've got one problem with it. From a cold start, usually in the morning, the 1st 10-15 seconds run rough before settling down to idle.

I have never seen any real large difference in NGK, Denso, and Champion if the proper heat range/type plug was used.

I'm not a fan of the old platinum Bosch design or regular autolite.

Yeah I own and operate an auto repair facility and refuse to use Bosch plugs because I’ve had a lot of issues with them in the past. Misfires mostly.

I've heard for many decades how bad Bosch spark plugs are and I figured the coils would be just as bad, if not worse.

Bosch spark plugs are junk.