Engine oil Mobil or PENNZOIL

Anyway, the only 508.00 spec oil I've found locally has been this Mobil 1 ESP X2 at Wally World. (walmart) Anyone else running it? Anyone seen any deep analyses? I put lots of Mobil 1 Delvac through 2 TDIs totalling 485k miles, so I'm willing to bet on this Mobil 1. I like being able to pick it up locally, and at only $28 for 5 quarts!?

I use either Mobil 1 ESPx2 European Car Formula 0W-20 available at Walmart or Valvoline Full Synthetic European Vehicle 0W-20 from NAPA. Both are approved VW 508 00 oils and can be cheaper than the oil at the dealer.

I’ve been running mobil delay esp 5w40 it’s been working well for me.

I've always put Mobil1 High Mileage in my 2013 Scion tC, IIRC Mobil1 is what Toyota uses at the factory. I had a heavy upper oil pan gasket leak that's largely stopped since switching to high mileage oil.

Finally ended up with Penzoil Plat. Can't tell a difference at all when the oil is fresh. Also engine never burned oil on Penz.

I have been running Pennzoil platinum euro in my 16 GTI its entire life and its now at 125,000km. I ran the same oil in my 2007 GTI before I sold it up until 190,000km. Never had a single problem, neither cars burned any oil.

I use 0w40 Mobil 1 all year round. I live in upstate New York, so our winters can get pretty cold at times, and summers can be in the 90s F for days at a time.

My V70 2.5T is almost at 190k miles. I add about 1 quart of oil between oil changes at 5k intervals and my car has been trouble-free since I purchased it at 107k miles in 2017.

Do not cheap out on oil. I use Mobil 1 high mileage but Castrol is also good.

I run 10-40 mobil1 in my VR now. had 5-30 and it ran just about the same, didnt notice any difference really.

I know when I put my stroker block in with stock head/turbo I filled it with 0w-40 and I would get low oil pressure when deaccelerating down hills.. Low enough the light would flash on, got my freaked out! with the new head. and my 71r 72a/r set up going on I'm swapping to 10w-40 mobil 1, because when I took the old head off there was a TON of carbon build up for the small amount of miles I had driven the new block around(less then 2,000 miles). I had changed the old twice already(once ot get the break in oil out and once again at 500 where I dropped the pan to check for metal and such and up in a new pick up tube for piece of mind). I have good reason to believe the 0w-40 is just too thin for the clearances for stroker pistons and such. I'll report back once the car is up and running with the 10w-40 in it. If the oil pressure problems persist I'm thinking about stepping up to 10w-50, but Im in southern California so YMMV depending on how cold/hot it gets around you.