Brake pads OEM Toyota or OEM Honda

2013-2015 have axle recalls…they’ll get fix free but you’ll need to invest in wheel hubs on the front due to the axles failing it’ll mess up the wheel hubs. Also the sensor on the battery it’s something about sending the correct volts to the alternator that’s a big issue and could cause electrical fires. Was also a recall. Besides that just check the car undercarriage for surface rust on calipers they fail a lot due to abunch of surface rust and debris getting into it over time and it’ll act like it’s seized up but really all the grease is just gone over time. Get good quality ceramic pads these cars squeal like a pig with the cheap ones. Also valve cover gasket is a must always will leak eventually every 30k miles or so. Best bet is getting a 2016 &up tbh

The CRVs I have are a 2010 with 210k miles. AC compressor every 100k miles and an alternator at 200. Brakes at 100k and 160k and 210k, the OEM brakes are amazing. Spark plugs at 100k and 200k and both times still looked new. Still drives amazing and is solid it's better than my 2017 CRV.

I run a fleet of Camrys and use Toyota pads because I've found that they produce the least brake dust and I HATE dirty wheels.

Nice. 2011 here (also bought new) but I did all four brakes at 68K miles. They had some life left in them according to the shop, but they just started feeling a tad soft, and my brake pedal was getting a little to close to the floor for comfort.

I bought my 2016 Prius used with 32k miles on it back in 2019. It now has 157k miles and the maintenance has been a breeze. Just standard oil changes every 5k, 1 transmission fluid change, two sets of tires and I don\u2019t even think I have replaced the brakes yet ..no seriously I don\u2019t think I have yet.

I've replaced a battery, 2 exhausts and brake pads in that time. Literally that's it, just maintenance and fuel.

Last week front passenger brake began making a metal on metal grinding noise. Assumed it was brakes because this vehicle has been a frequent brake pad/rotor-replacee due to the mileage of the car. The brake pads were very low. Drove the car around for about 30mins today and no grinding noise BUT the front passenger was very hot and didn’t smell good.

After bringing the knuckle back, we reinstalled the brake pads. We had a difficult time getting the pads to sit correctly, specifically with the anti-rattle clips (prongs). Eventually, they seemed to seat properly, and we reattached the pads and caliper.

Bought a 2012 Toyota Sequoia from Heritage Motors on Shore Drive with a fresh inspection on it, So I personally figured it'd be solid, as Sequoia's are known to be pretty dependable. Not only was it a lemon/some huge issues, but the brakes were slapped together with bubble gum and hopes and prayers. The brake pad on the passenger side was installed backwards, which I was shocked it didn't make noise on the test drive

It had about 35k miles on it and the service rep said it failed due to the front brakes being worn down to the rotors.