Brake pads OEM FORD or Hawk Performance

Hawk Blues are the best I’ve driven on a street driven 930 being used on the track. Thousands of laps with different compounds. Or HPS+ if you’re not that aggressive.

I use Hawk Blues on-track and street pads off. Pads are so easy to change on our cars that it is only a 30 minute job to swap before each track day once you have some practice. The Blues are very abrasive and will clean any bedding material off the rotor if you just lightly ride the brakes for a few minutes while the pads are cold. The Blues have plenty of stopping power when cold on the street, but squeal a lot and eat through rotors very quickly. On-track they have been fade-free for me with excellent modulation using ATE TYP200 brake fluid.

I really liked the Hawk HPS 5.0s on my WRX. Good enough for the track and plenty comfortable for the street

I put Hawk Performance drilled and slotted on my 2017 STI. Ceramic pads. Have saved my car a couple times when assholes decided to jump the line and do a U-turn in front of me.

I swap mine the day before. They aren't race pads, just hawk hp+. I wouldn't want to daily them, they're loud and dusty but work totally fine on the street so I drive them to my track days

I think getting some nice aftermarket brake rotors and hawk pads would be good.

My Ford C-max hybrid has 113k miles on it. It's engine has around 80k miles on it. I change the oil like once a year. I've never touched the brakes because it barely uses them.

I recently did the Hawk 5.0 pads and they are lacking on initial bite. Bit disappointing. Much better for repeated breaking tho, as they warm up.

I used these Hawk brake pads for a HPDE track day so they did get very hot. They still have 10mm of thickness left, but this particular pad has these very pronounced cracks. All other pads have very minor cracks (barely visible), but this one was the worst.

I ran Hawk DTC60's for one event. They dust like crazy which isn't the end of the world by itself, but if the dust touches any moisture at all (like the rainy track day) it mixes into what I can only describe as ferrous concrete. So not only is the dust-crete impossible to remove by any normal means, it then rusts like crazy, turning whatever wheels you have into a runny orange mess. I tried multiple different wheel cleaners, multiple brushes, soaking, anything and nothing could get it off. I had to use scotch brite and scuff the hell out of the wheels to get it off. Fortunately I run cheap TRM wheels and it's a track-only car otherwise I would have been livid.