Brake pads OEM FORD or Hawk Performance

I am stock turbo FBO (engine wise) FiST, switched from Powerstop Trac Day Spec to Hawk DTC-60 with good results.

I’m a big fan of how my brakes feel after upgrading to the Hawk HPS 5.0 pads, Bosch solid rotors (drilled/slotted do more harm than good), and some Goodrich Stainless Braided Brake lines.

Front - OEM rotors, check Lexus parts too, same same, with Hawk Heavy Duty pads. Rear - Centric or OEM rotors and oem pads. Fluid - Pentosin DOT 4 Low Viscosity brake fluid. Full fluid change every brake job.

Zimmerman blanks and Hawk HPS pads, Motul 5.1 fluid. Initial bite is as good as if not better than stock, but they seem to get much stronger with some heat in them. Biggest plus is the massive decrease in brake dust.

Hawk hps 5.0 and blank Zimmerman rotors

Whole setup feels really damn good.

They're quite a good combo. I glazed them doing too much drifting in the snow, but fixed with a bench grinder and they're as good as day 1.

I’ve got StopTech st-40’s and run Hawk HP+ pads. They have good bite and hold up pretty well, they’re just SUPER loud until they’re hot and are also fairly dusty

I was leaning toward trying Hawk HPS pad for the GSW, but I first put them on my Focus ST and while I'm satisfied with the performance, I'm disappointed in the noise level; I have a squeak that I cannot eliminate, even after taking them off, re-bedding, and meticulously applying brake grease in the right spots.

Not only do they do that, they're a terrible autocross pad. Dust is something that happens with pads that stop there are very few that stop and don't make dust. However there are different types of dust, stuff that sticks to everything and stuff that wipes off easily. But the problem with those pads in general isn't even the dust it's there very on off switch nature. They're very powerful and they're very grabby and they do not release well either which makes abs fight a lot more to do its job.