Brake pads Ferodo or OEM Audi

I used DS2500 for my first 2 track days but outgrew them rather quickly on a 2800 lb car. Last time I swapped to DS1.11 and felt much more confident braking deeper into corners with zero fade at my intermediate level. Now I just use DS2500 for the street and canyons.

if you want raw stopping power then Ferodo DS2500's are great.

I was a huge fan of Ferodo DS2500s on Centric rotors. They performed insanely well for street duty and were decent enough for track days.

Ferodo DS2500 is about the best pad you can get.

I've got OE spec ferodo on my 208 GTi no complaints from me, got brembo on my Saab 9-5 aero again all good I would avoid the cheaper end of the market

When I replaced my rear brake pads and rotors earlier this year - he straight up told me that the front pads were almost out but the rotors were good and since this particular dealership needed you to replace both together - he recommended a local German auto shop that would replace just the brake pads.

Ferodo DS2500 were good in my daily/tracked GTI and track NB Miata, until I got GLOC track pads on the latter. Which are awesome. BUT the DS2500 held up to the track really well, I'd definitely say for a daily that gets tracked they're about as good as you might get. Grease the contact points on the pad with copper or other compatible grease and i think they don't make much noise at all.

I’m running DS2500 on my GTI and they are just not *quite* robust enough as I have progressed into the more advanced groups.

I switched to the Ferodo DSUno. I am satisfied with its performance, but they seem to struggle because of something. Today, after the track day on Saturday, I checked it and found a crack and a gnawed edge. Also, they have uneven wear, about 0.5-1mm difference. The differences are between the top and bottom parts of the pads, front and back parts and on different sides of the same rotor (inner and outer pads). Uneven wear was with the old pads as well. Recently, I installed brake air ducts, and after going out from the track, the temperature was, in the worst case, 480C degree, which looks fine for these pads. In total, I drove for about 3 hours on tracks, one on a wet track (so no hard braking) and two moderately/hard(8-9/10) braking. The brake rotors are also new, Zimmermann blank, installed with pads. The initial thickness of the pads is 16.4mm (with the plate, the plate is 5.5mm, so the "pure" pad is about 11mm) Currently, I have eaten about 4.5-5mm of the pads in 3 hours of tracking.

they're Audi pads, with Extra squeek!