Brake pads EBC or WAGNER

They'll absolutely be ok to use for the street. In fact, most supersports come with oem HH sintered pads.

They may wear a little quicker, but you'll get better stopping power and you should certainly feel a difference.

I recently changed the pads on my 600RR to the EBC HH sintered pads and I'm really happy with how they feel.

The inability to easily modulate light braking is the main reason I swapped in some EBC Redstuff pads. Very linear and better ultimate braking. You couldn't pay me to go back to the stock pads.

With EBC Yellowstuff Pads and Motul Fluid I was fade-free during multiple 25 minute sessions at my local 2.5 mile track. My front brake rotors read a temp of 650 degrees at the end of each session with ambient air temp of about 85 degrees.

Here's what I did at 30k miles as the originals had faded badly StopTech slotted rotor with EBC redstuff pad - I'm certain you'll get a thousand recommendations on better stuff. Love, love, love these brakes. Very little dust.

I went from OEM to ebc yellow stuff to combat brake fade on the track. I feel a bite difference on the road for sure. If you don’t mind a bit of squeak, the ebc brakes are good.

I also upgraded brakes to Optimal brand e-cote rotors and EBC Red street/performance pads. A nice improvement in brake feel and the new rotors look better, but hardly necessary.

Calipers cleaned up with new EBC pads, as well as a complete fluid flush.

Just had Stoptech slotted front rotors, EBC ceramic brake pads and Motul DOT 5.1 brake fluid installed on my 2016 GSW....BIG improvement at reasonable price....

Ok, so, at a particular location I worked at we used Wagner Thermoquiets. Decent pads, but this particular location seemed to get the worst quality pads ever. The only way we could keep the customer from coming back was to make sure everything was well lubricated, and we also used some sort of orange goop to stick the brake pads to the calipers. Then we took it out for a break-in session, I believe it was 5 stops from 30mph, gently using the brakes, then another 5 with moderate brake pressure. And if the customer was too hard on the brakes it might still come back.

We had really bad luck with EBC yellows, had a pad seperate from the backing plate, then the next set warped after one track day. Never again.