Brake pads Carbotech or OEM Mercedes

I track a WRX and have used XP12's in the front and XP10's in the rear. They work very well. IMO Carbotechs are one of the best for the track

Carbotech and dont look back, many proven won championships and leading modular pedal feel. I run them and love them !

I ran xp10s on a Jetta with no issues. They got really really hot, but no fade or loss of pressure. It was so hot it melted the tabs that held the plastic center cap on my wheel.

I run carbotechs on my GT350. Multiple weekends on them.

Been running carbotechs on my m2comp and C's and 2 seasons. Love them. Xp10 up front, xp8 for the rear. Track only pads that I can drive to the track with

I’m running Carbotech XP10 in my AP’s and the cold squeal is obnoxious. Once they’re really good and hot it goes away but it’s definitely just a trade off of good pads. Mine drag every so slightly when turning the wheel by hand but never enough I’ve been concerned about it. They still work very, very well.

I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps

XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this

im running XP10s... so far this set up is amazing, the braking is strong initial bite with little fade. Just take in consideration that this Carbotech pads are modular which means you will have a slight longer pedal travel than normal. And yes they are super noisy, when i drive it on the street i try to be careful with my braking and not feather the brakes, that will make then literally screech and grind the rotors, instead i try to brake a bit harder than usual to get a good bite and then let go of the brake once i stoped (put the car in neutral most of the time or creep forward little by little to releave some heat).

MB advisor here, GLC brakes are horrible with noise.