Brake pads Brembo or OEM Nissan

They’re fantastic. Got a set when I swapped in brembos last summer. Amazing braking power and minimal fade.

4 years ago I had my daughter, before taking my 2008 Mazda 6 back to college with her, install new Brembo "OE"/standard type pad sets front and rear and new Brembo rotors in the front. The front pads and rotors were so thick that the caliper piston cups had to be ENTIRELY retracted into the pistons to fit over them. After completion of the job and the performance of the pad/rotor break-in procedure, the already capable car was turned into a braking performance monster. It was like if you depressed the brake pedal a millimeter the car would start to decelerate markedly! And rapid stops were unbelievable quick and drama free. So I absolutely recommend Brembo products (have installed Brembo pads on 2 SUVs as well) and have always been impressed with the results!!

The fronts are basic Brembo, so as long as the mech. is competent that shouldn’t be an issue.

I put in cheap ceramic genuine Brembo pads in my Kia, stops on a dime.

A popular way to get bigger brakes on your Honda civic is taking the brembos from an Acura TL.

The OEM brembo pads and rotors on my Subaru would leave a lot of buildup for sure. A couple good hard brakes and it was clear.

I replaced all brake pads and rotors about a month ago on my 2014 Honda Civic EX with Brembo pads and rotors. So far they're working great, huge improvement over the warped front rotors and the warn pads before.

i have an 80zx with an sbc swap, i’ve rebuilt all 4 brakes, replaced a master, swapped coiled did bushings replaced u joints

All 135i have brembo supplied oem brakes. They sure do look great and have 6 pistons up front. But, the functionality of said brakes are not more special than what BMW offers for the 335i and Z4 of the same generation.

break pads don't last very long