Brake pads Brembo or Mintex

Had my Fortuner front pads replaced, Brembo Prime Ceramic Pads: 3500 lang kasama na install sa Jiga.

You can save on the brake pad prices, either buy the original parts from a shop in sharjah for much less or install Brembo Brake pads which also cost much less and are also very good quality.

I swapped front pads with a 13mm socket, hammer and drift pin. In about 30 mins in my driveway. $210, parts delivered from Amazon. Took the opportunity to scrub out calibers free from all the caked on brake dust. Cleaned the inside of the wheels while I was there. Dealership wanted $787 just for the front pads and quoted more than $1000 installed. Easiest job ever and saved $500-$700.

If you DIY and have the tools I did front and rear brakes on my 340i with brembos for $725ish

I have 45k miles on my 2016 STI and just replaced all 4 rotors and pads with another set of Brembos. I don’t drive the car particularly hard and probably could have waited a bit longer but they are done now so I shouldn’t have to worry about them. Cost me about 1k all-in, parts and labor.

I just put some Brembro low met pads on out SQ5. They are more progressive bite, but I like them better than the Hawk HPS 5.0 on my S4. When you get on them they stop very well. Not sure on dust yet.

Mine squeal sometimes at 5-15mph. Stock Brembo pads too.

I have a 2017 BRZ with the Performance package 34k miles. Brembo's squeal when slowing down at around 5-15mph. The dealership can't figure out why it's squealing. I found some forums where brake squeals are normal for Brembo.

Not to sound mean, but Mintex redbox are terrible pads.

Mintex Red Box pads are crap - the company changed hands a few years ago and quality has sucked since with some folks experiencing large chunks of pad material just falling away.