Brake pads ATE or OEM Toyota

OEM Toyota Brake pads
The_Shepherds_2019
  • Braking:
  • Noise:
  • Dust:
Rating 5.0

I'm now at 120k miles. Still have over 4mm on both the front and rear pads, and the rotors look fine. So that's at least 50k miles I'll get out of a set of OEM brakes, but I expect more like 75k. 6 speed hatchback if it makes any difference.

I can't imagine a situation where I replace them with anything other than OEM Toyota parts. They've lasted an impressive amount of time, rarely squeak, and don't make any dust.

Pros: long lasting, no squeaking, little dust
Mileage: 120000 km
Comment
Is this review helpful?
source
ATE Brake pads
Agitated_Line_2853
  • Braking:
  • Noise:
  • Dust:
Rating 4.0

OEM brake pads from Audi are mostly good for day to day braking, and some sporty, but not daily very aggressive driving. But they do a lot of dust and noise sometimes. I found the solution to be just change the pads for "ATE Ceramic" if you don't use your car to do track days and very frequent sporty driving. These don't have ceramic components, it's mostly marketing, but they do have two good characteristics from Ceramic pads, mostly zero noise when heated and almost zero dust! And the low dust it produces, it's not black. Breaking power it's maybe a little better coming from OEM, but nothing crazy. Do not use sport discs with ATE Ceramic, the brand actually advises to use normal discs with these.

Pros: low dust, low noise
Cons: less breaking power
Vehicle: Audi A4
Comment
Is this review helpful?
source
OEM Toyota Brake pads

I purchase a 2022 highlander brand new. Recently it hit 50k miles. Purchased pads... Only assumed they needed them. Broke everything down to find they weren't even at 50%. Replaced them anyway - but they could have easily gone 80-100k depending on how I drove.

Pros: long lasting
Vehicle: Toyota Highlander
Mileage: 50000 km
Comment
Is this review helpful?
source
ATE Brake pads

YES! i have the same issue and its mental. DBA Slotted Rotors and the Street Performance (Green) Pads, clunk over bumps and when moving back/forward D/R etc. Rattle is 99% from the left side / without the depth check. DBA said to extend the shims so they stick out further, and it works temporarily for about a day, then back to normal. Everyone is recommending the ATE pads, so I might try them, but if these rattle too not sure what to do...

Pros: works temporarily
Cons: clunk over bumps, rattle
Comment
Is this review helpful?
source
1 ... 2 3 4 5 6 7 8 9 ... 13

Write your review

Help others - share your experience with this part.

Other comparisons
Loading...