Brake pads Akebono or Carbotech

I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps

I replaced my pads at 70k from factory. Had ATC on the whole time and I use PROPilot Assist and Intelligent cruise control often and most of the time it's together. Very minimal pad wear after replacing. The factory ones squeaked when it was cold but would go away after some heat, I went with the Akebono ASP pads this go around and no noise at all.

XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this

I just switch between track and OEM pads. I can usually get 4 to 5 tracks days out of the Carbotechs that I run. I drive my car to the track, so by the time I get there the track pads have had plenty of time to make friends with the rotors. Same thing with the OEM pads. It just take a little bit of driving for them to settle in.

carbotech xp10/xp8(f/r), not a daily but the car sees plenty of street miles. they are noisy and dusty but this setup has been perfectly fine for me.

I got the Zimmermann coated rotors and Akebono ceramic pads from FCP Euro. The braking power and smoothness are way better than what I had with the scrapy metal sounds before, lol.

I went from stock pads directly to Akebono ProACT. Once they bed, they will feel be the same or better than stock. Not rough, not loud. I mention the bedding wait because initially the bite wasn’t there and I was a little concerned but after the pads ate away the protective coatings on new rotors it was the same or better.

I paired centric rotors with akebono pads and they were great

Akebono isn't bad, but I usually go with oem brake pads if available.

I did not like the Akebono ASPs at all. A distinct lack of bite even after break-in. Went back to stock and all was good.