Brake discs STOPTECH or MEYLE

I have drilled and slotted rotors on my MK7. I have never had any warping or cracking issues with them, or one any other car that I've ever had with them. Performance wise I've never noticed a difference between stock or drilled/slotted rotors except for in wet conditions. When it's wet out break feel is MUCH better with drilled/slotted rotors.

+1 for stoptech st-40s, they're slotted 328mm rotors and 4 pot calipers. Car brakes really nice. Kept the stock rears, although had to replace calipers at about 120k as they were starting to seize. If the car sits for a few days, the rust builds up (I assume in the slots) and makes noise . Goes away after about 30-40 miles. Not sure if drilled would be better. I definitely don't regret it, but modulation from the 4-pot isn't improved the way I thought it'd be. For the same price or just a tad more I could've gone with R32/GolfR/etc. front and rear, I'd probably do that if I were to do it again.

About a year ago, I installed a complete Meyle control arm kit in my B7 A4 Avant . At the same time I installed a set of Meyle geomet coated rotors and Akebono ceramic pads on all 4 corners. The car still rides, handles and stops like new. The rotors still look new with no warping and no rust after a tough New England winter.

I'm running Corrado G60 11.0" front calipers and carriers, and MKIV alloy rear calipers on my 97 Jetta GT with Meyle plated rotors. The rotors are about four years old, and still look almost new. A few small rust dots are showing, but not the massive rust that you see on most two and older rotors, and virtually no wear of the friction surfaces.

That is not true. I have been running the StopTech BBK with 355x32 floating rotors (Z4M Coupe, 3275lbs + me) for over 2 years with 25+ track days on them and they have not warped.

I've had Meyle Corrado G60 11.0" 4-bolt rotors on my 97 Jetta GT for two years, and they are barely wearing (plating is gone off the friction surface of course, but holding up well over the rest of the rotors).

I'm kinda partial to Meyle plated rotors. They're inexpensive, high quality, and appear to be wearing well on my 97 Jetta GT (Corrodo G60 11.0" front calipers and rotors).

I'm running the coated Meyle rotors and have been pleased with them over the last year. They appeared to be well made out of the box and fit well, especially for the price. The anticorrosive treatment is holding up well too.

No, the Corrado G60 11" 4-bolt rotors bolt right onto the MKIII 10.1" 4-bolt hubs. I bolted on Corrado G60 Girling 54 11" calipers and Meyle Corrado 11" 4-bolt rotors to my 97 Jetta GT without any problems at all.

I've just finished upgrading my 97 MKIII Jetta GT from 10.1" to 11" Corrado G60 brakes, I know what you're going through, because I've made all the mistakes.