Brake discs Detroit Axle or Duralast

I like the duralast gold brake rotors. They have a really nice coating to help prevent corrosion, if you’re in the north east I really recommend them. They do need to be bedded once installed to get rid of the coating on the braking surface of the rotor. You pretty much just get the car up to 20mph and hit the brakes a little aggressive, you do this a few times each time increasing your speed. It comes with clear instructions how to do it.

Dynamic Friction makes a good geomet-coated rotor that is excellent for what they cost.

Dynamic Friction are great with ceramic pads, only complaint is cosmetic, they do not coat the rotors so after some rain the inside hub of the rotors starts to rust. Purely cosmetic, great rotors! I drive them fast regularly and they perform better than OEM

when I did the brakes on my ‘17 GTI about 20k miles ago I used Duralast Gold rotors and pads from AutoZone. Low dust, low noise, stop fine and the rotor hubs are coated so they don’t rust in five minutes. They’ve been perfectly cromulent.

I use Duralast Gold rotors on my two endurance race cars - they are great. I wouldn't expect the basic ones to be anything special, but they should work just fine.

i have detroit axle slotted and ventilated, might be drilled idk don’t feel like checking rn lol, brakes nd they’ve been pretty good the past few months i’ve had em

I had them on my Z32 a few times, not bad, I wouldnt do track days with them, (well I did once they warped). But outside of that, for daily they are fine.

The EBC Yellowstuff pads didn't last as long as the OE pads. The Alfa EBC rotors still are shipping with Gen1 "ThermicBlack" coating on them, which isn't as good as the Geomet/Geospec coating that EBC claims to now be using on new production parts. The EBC Gen1 coating rusts and looks like a pretty nasty rotor in just two years. I went with the EBC rotors in 2021 because I didn't want Chinese parts either, and the EBC items are made in the UK (and pads may be made in the USA).So when I did the rear brakes again this year (rear EBC YS pads shot in 23k miles), I went back to the OE Alfa rear pads. I ordered the EBC rotors, but when they showed up with the Gen1 coating that sucks, I returned them. And I ended up having to buy Dynamic Friction Geospec/Geomet coated rotors, which are made in China. The Dynamic Friction rotors were well packaged (much better than the EBCs). So far, they're completely fine after maybe 100 miles.

That's likely the lowest possible grade of rotors I've seen in a while. Lathe marks are too rough, and the casting is bad.

I had the Detroit axel rotors on my fronts for a while and they were just a little too small and caused the pads to squeak after a while from uneven wear since part of the pad didn\u2019t hit the rotor due to it being a couple millimeters too small.