Spark plug NGK or OEM Volkswagen

NGK Laser Iridiums will last longer, but those aren't bad per se.

I had to put a new spark plug in mine after only a few hours of use. It had some China branded in it and I switched to NGK. Also propane creates a hard harder to jump spark gap so you generally have to narrow the gap a tiny bit from typical specs when you’re going to run propane. Since I only run propane I went down a little on the gap and it runs flawlessly. I optimize the gap width by seeing which widths responded best to a sudden surge load without hesitating.

NGK Lazer Iridium Plugs is what I got to replace them in my car. I believe those are what Mazda OEM plugs are, but it’s just cheaper to buy the NGKs from a part store.

use NGK spark plugs, the best ones are the PFR6Q

Pick up some genuine Audi R8 Red-Top coils (not kidding, much lower failure rate) and some fresh NGK Iridium spark plugs.

I had this very same problem where on my 07 V6 the acceleration and power was off. I had replaced my spark plugs with NGK Iridium plugs and after dealing with the horrible performance I decided to change them out for OEM platinum (copper) plugs. This made a huge difference and could immediately tell a night and day difference. Regained the torque and power that was missing.

I've run the NGK ruthenium in my sierra with the 6.2 and they ran great but I notice they aren't the right gap.

I do NGK 6510 one step colder. I do 0.025”-0.026” gap. I had a shop do my last set since I didn’t trust myself. He accidentally did 0.022” and I put them in and they’ve been fine. The other set is 0.018” and idk if ima put them in. Gotta change the one step colder NGK’s at around 15-20k miles. I usually change mine when I start seeing high spark retard. I’m BT 93/E40 with aux.

I learned that proper, very hard to tell, NGK knock offs even existed after I was bitten by fake ones off Amazon. The porcelain around the center electrode broke off and went through the engine.

I have installed brand new NGK sparkplugs and Bosh ignition coils...but the cylinder 1 misfire does not move or is resolved at all.