Oil filter Fram or STP

I'm happy it ended my cold start rattles if nothing else. I'm just curious to know if you would still see 240 temps with the oem filter....or even a crappy Fram for that matter.

My filter looks just as I put it in after 5,000 miles, just dirty.

I have been using these since I bought the car (4 years ago) and they have filtered the oil fine, and also look just as the OEM ones did when it was time for an oil change.

I use fram a lot, never ever had a problem.

I don't think Fram filters are all that bad. I've used them before with no problems. I have been scared away from them, though. There are much better filters out there for a couple more bucks. I have not read any horror stories on the 'tex about a Fram actually causing an engine to die, but maybe I have not looked hard enough.

cut a few fram filters before and they were horrid. if you do use a fram filter, use the Xtended Gaurd, much better then the fram PH filters

Years ago Fram was a quality filter manufacturer. Now their standard filter (the radioactive-orange cans) is one of the worst out there. These filters are manufactured by Allied Signal, Inc. Please do not buy these filters. By boycotting it, we may be able to cause some change. I have personally had one if these filters fail and actually cause engine damage due to bits of paper and glue floating around in the engine. For some inside dirt on Fram filters, see this email from an Allied Signal production engineer. " "Fram Extra Guard PH8A This filter cartridge has a small outside diameter with a rather low filter element surface area (193 sqin), and features cardboard end caps that are glued in place. The rubber anti-drainback valve seals against the cardboard and easily leaks, causing dirty oil to drain back into the pan. If you have a noisy valve train at startup, this filter is likely the cause. The bypass valves are plastic and are sometimes not molded correctly, which allows them to leak all the time, but they often leak anyway. The backplate has smaller and fewer oil inlet holes, which may restrict flow, and is made of thin material.

Get a dealer filter, or Mahle or something, don't get a Fram. I use a Fram on my 66 Mustang 289, but not on my 1.8T.

Oil filter Mann/Mahle NOT Fram... much better quality than fram.

the fram's are junk for the VR, the flow(filtering ability) may be different and the pressure valve in the filter is funky(if it has one I can't remember).