Oil filter Bosch or OEM Honda

I buy Bosch filters through Rock Auto and oil during the Fleet Farm Black Friday rebate sale so my oil changes cost less than $10.

The Euro oil (which I seriously doubt Valvoline used) is about $30 for a 5q jug + $10 for an extra quart, and a Bosch filter about $15.

Try using an OEM Honda '03' oil filter (the filter code ends in 03). This should solve the noise it makes only when the engine is cold. This happens because other filters don't retain the oil properly, causing a slight delay of about a second when you start the car to lubricate the timing chain, resulting in the noise.

I had a similar thing happen on a 07 Honda Civic. Ended up being a bad oil filter ( split at a seam- deemed a manufacturer defect ).

I tried to buy a filter, a bosch is a decent choice, but I wasn't able to find it, or I should import it for 100 sar ( which is expensive, most filter sold for 20 to 50 sar where I live - saudi arabia -)

Been using honda 0w-20 and honda oil filter sa city ko and no problem so far since regular naman pagpapalit ko ng oil.

Make sure to change the drain plug crush washer if you don't do at the dealer and get good quality filters (Bosch, Mann)

So that DTC sets when there is an oil pressure issue originating from the oil filter up to the bank 2 VTC solenoid and actuator, using an aftermarket item could possibly lend to this issue

I ordered these 15400-RTA-003 oil filters on eBay for my FL5. The box and shrink wrap don't match the photos in any of the listings I've seen on and off eBay, except for this one place, which seems kind of suspicious.

i’d like to introduce you to the honda k series. filter on back of engine, hard to reach from top, hard to reach from bottom, easiest but still hard from wheel well. oh and if it’s a honda element or CRV, it pisses oil all down your subframe and axle shaft.