Brake pads WAGNER or Hawk Performance

Hawk hps 5.0 and blank Zimmerman rotors

Wagner OEX. It's built on a galvanized steel backing plate so it doesn't rust like the painted ones. It also uses a mechanical attachment system to hold the friction material instead of glue, so it won't crack/detach like the cheap pads.

Whole setup feels really damn good.

They're quite a good combo. I glazed them doing too much drifting in the snow, but fixed with a bench grinder and they're as good as day 1.

Hawk Blues are the best I’ve driven on a street driven 930 being used on the track. Thousands of laps with different compounds. Or HPS+ if you’re not that aggressive.

I use Hawk Blues on-track and street pads off. Pads are so easy to change on our cars that it is only a 30 minute job to swap before each track day once you have some practice. The Blues are very abrasive and will clean any bedding material off the rotor if you just lightly ride the brakes for a few minutes while the pads are cold. The Blues have plenty of stopping power when cold on the street, but squeal a lot and eat through rotors very quickly. On-track they have been fade-free for me with excellent modulation using ATE TYP200 brake fluid.

I really liked the Hawk HPS 5.0s on my WRX. Good enough for the track and plenty comfortable for the street

I was leaning toward trying Hawk HPS pad for the GSW, but I first put them on my Focus ST and while I'm satisfied with the performance, I'm disappointed in the noise level; I have a squeak that I cannot eliminate, even after taking them off, re-bedding, and meticulously applying brake grease in the right spots.

I recently did the Hawk 5.0 pads and they are lacking on initial bite. Bit disappointing. Much better for repeated breaking tho, as they warm up.

Should’ve gone with EBC! Tried Hawk hps blues and could not go more than 500 miles before taking them off and replacing them with EBC yellows again. The noise was horrible.