Brake pads STOPTECH or OEM Mazda

Stop tech sport brake pads have been great to me.

I replaced them both with stoptech pads and rotors. Good quality and price.

At 55,XXX miles and still haven’t changed my brakes on 2019 AWD Mazda 3(not as heavy as yours but heavier than a FWD 3) Last service, I was in the green for both sets still, but they said I would likely be in “yellow” by 60-65k. I did want to note—I hear no scraping/squealing and brakes feel relatively strong just not as great as new.

I run Stoptech 305s and they exceed my expectations

I did Stoptechs in the front and Golf R rears, I canyon carve in it and the brakes are legit. Heavy, heavy repeated braking, no fade.

Stoptech Street pads for the Akebono brakes. I've only got 16k miles on them and they still look new, despite having drilled & slotted rotors. I do heavily downshift and engine brake, which explains the lack of wear. I'd buy them again as they're quiet, but they do produce a fair amount of brake dust.

2015 sedan. I did my brakes last spring. I went with OEM as I found them cheaper than any aftermarket I could find near me and as far as I knew I still had OEM on my car and had lasted me a long time. Zero issues since having them installed, I’m happy.

The only difference I noticed with Stoptech is more dust.

oem brake pads are ceramic (low noise, low dust, minimal rotor wear, less bite)

easy 40 minute job to replace brakes on my 14 Mazda 3 took about two hours. It all pops off super easy going great. Go to put them on, well shit they don't fit. Try the other side for some reason thinking I'm just having a stupid moment. Doesn't work either.