Brake pads Raybestos or OEM Nissan

I like them. Used them for 2 years and have a lot of backroads and a couple of track sessions on them. The shims that come with them rattle a lot.

I recently replaced my factory Kia front pads with some EHT's. Did not replace rotors, just cleaned and removed some rust on them. Applied some caliper grease to the proper areas and these pads so far have been really nice. A VERY noticeable difference vs. the factory pads in stopping power. My only complaint was that Raybestos did not include new pad retainer springs in the box.

Guy above says don’t go cheap….I just used some raybestos pads and rotors for the rear I got from rock auto for 100$. Cheap, fast and easy. First time doing brakes and despite some snags had it done in an hour.

Fitted my 2017 with new front/rear brakes and rotors yesterday. I went with the daily driver level Raybestos brand kit from Rockauto. Included both pads and rotors with hardware. Did the work myself. While I obviously can't say anything about longevity yet, performance seems good so far. Especially for the price when compared to over double for Duralast from my local AutoZone.

I've had great results from Raybestos ST43s and Ferodo DS2500s for dual duty.

I'm using raybestos SP436ATRH for the pads and raybestos 96632FZN for the rotors. Been using them since January and have put about 6k on them, living in a really hilly area with my drums being basically useless because the shoes have been coated in gear oil due to an axle leak. I javent had any issues with brake fade or warping and I took them on a 2hr trip to west virginia from central ohio in March.

I replaced my rear pads with Raybestos EHT1761 at 23,000 miles. I did not replace the rotors as they were undamaged. I did buy rear rotors, Powerstop EBR1697EVC. I am at 37,000 now with no dust, no noise, and minimal pad wear.

I use these pads (and rotors) on my FX35. A couple things I have noticed:

1). There have never been appropriate rattle clips included with any set of pads that I have ever purchased for this car…ever. I am still on OEM stuff at 180k miles. That isn’t just Raybestos. I even ordered Centric hardware…no dice. Not even close. Mind you, I always order model-specific hardware. No idea what the issue is, but it is clearly for the wrong car.

2). These pads take a few stops to heat up, which I kind of expected. I am satisfied with them on my daily, but the rotors are another matter entirely. They all warp within a month or two. That is odd considering they advertise the construction as Dura-Bar. That should be pretty resistant to that kind of thing. They definitely don’t hold up like Centrics do.

3). The shims have a nasty habit of falling off. Not while driving, but during service. You have one maybe two removals before they go MIA.

Other than that, I am not sure that I have noticed an issue with the pads being either wrong or out of tolerance. That is very not what I would expect from a brand like this.

I replaced the pads and rotors on my Jetta this past spring. I put on Raybestos Element3 pads and coated rotors, and I've put maybe 6k-ish miles on them since then. Everything was fine for a while, but lately a squeal started to slowly develop until now it's every time I use the brakes. It sounds exactly the wear indicator noise I'm used to hearing when pads are low.

break pads don't last very long