Brake pads R1 Concepts or Hawk Performance

I currently use Hawk DTC60’s on my Scion FRS with Motul RBF600 fluid for track days. The brakes feel great to me, I like the bite, and they don’t fade even on multi day events.

I just switched to R1 concepts Geomet pads, and drilled and slotted rotors. They're just as good as OEM from what I can tell.

Just switched to dba t2 w Hawk ceramics (combo set from new provisions racing) w factory calipers and lines.

I’d been considering brembo swap, but money had to be reallocated, so I abandoned full upgrade dreams. Old rotors were warped and pads were a dusty mess, so pretty much anything was an improvement.

Hawks are quiet, super-smooth/consistent engagement when I step on pedal, and minimal dust. Definitely happy w decision.

R1 concepts were an upgrade on my 2nd gen and got me through 4 years of abuse because the OEM ones would brake fade terribly. On my Camry they only lasted a year.

I got my rotors turned and threw some hawks in it. HPS I think. No issues and they have good bite.

I put a set of r1 concepts pads and rotors on my wrx that I daily got them off Amazon for like $250 and came in like 2 days had them on for around 7500 miles and haven't had any issues.

I run non-oem pads on my t6 but that’s because I like more initial bite when I step on the brakes. I use Hawk street performance pads. They definitely make more dust and sometimes more noise than OE pads.

Had one in 2012. A cba 2009. Blew transmission. Covered under warranty. They put in a DBA transmission and bellhousing. Had full bolt ons and the car was fun. Ran mid 10\u2019s at over 130 mph. Stock brakes sucked. I upgraded to J hook rotors and I think hawk pads.

I've had mine for like 60k miles. 87k ish on the clock. Just changed everything. Yearly inspection and the shop rejected it for brakes. Brake installer said the weren't that bad. I bought an R1 Concepts kit. Front and rear rotors plus pads all around. $220 shipped on Walmart+ (also found on Amazon or Rock Auto). The shop had a brakes special: $160 installed for new pads. Since I had the parts and rotors take like 30 seconds to swap out, they charged me for two brake installs at $150 each. So all in installed was like $550 after taxes.For reference: the shop that rejected it quoted something like $500 for the front and $500 for the rear. And I don't think it was all new everything.

Should’ve gone with EBC! Tried Hawk hps blues and could not go more than 500 miles before taking them off and replacing them with EBC yellows again. The noise was horrible.