Brake pads POWER STOP or OEM FORD

I just did my brakes for the first time. Way easier than I expected. I think I spent $700 on front and back Powerstop Z36 pads and rotors.

I had Z26s on my first TSX. Those things made my stock brakes feel like a joke. They also look cool on the car too. I'm planning to get them again for my current tsx when it's time to replace my pads.

I ran powerstops on my P71 when I did them and have run them on most of my vehicles since, they\u2019re great brakes for the money just make sure you follow the bedding-in instructions.

I paid $750 for it in 2007. It had a lunar odometer (north of 400,000) and the gas gauge stopped working so you had to write the mileage on a sticky note and slap it on the dash. The seat belts were *sawed off* and all the safety features deactivated. The brakes were high-dollar Brembos and I owned it for three years as a scrap hauler and fishing access get-to-er. I sold it for... $750. To a teenager. He probably still has it. 91-95 F-150 for life. Those things were TANKS and will survive the apocalypse, same with the Chevy 1500s of the day, especially the Silverados.

I upgraded mine with powerstop z26 pads up front with their slotted and drilled rotors, and z23 in the rear with slotted and drilled there too and stops on a dime and I dont ever detect any brake fade and I drive fast in steep winding roads and up Mt roads with it

PowerStop ceramics. I put them on the fronts. Dust was crazy on the OEMs

Unless you do extreme driving (lots of mountains runs, hot laps on track, etc) slotted and or drilled rotors are a waste of money. They will cause much higher pad wear. Spend your money on good pads and buy meh rotors to get best bang for your buck and longevity.

Powerstop z23/z26 are both pretty good, have ran a couple sets.

The z23 pads handle heat better but they’re not that aggressive in terms of needing to warmup. Its still very much a street pad. For me pedal pressure feels stiffer but slightly spongier than stock if that makes sense. Not a bad thing just something to get used to, and you get used to it quickly. I’d recommend them.

powerstop z26 (just know these are noisy so lubricant them right, I recommend synthetic brake pad lubricant).

The Power Stop pads do have the end clips but they are moving in the calipers a little. After following the break in instructions that include hard braking the metal sound pad on the outside of the pad slid up and wrecked it somewhat.