Brake pads POWER STOP or Hawk Performance

Happy to report that the Powerstop Z23 front pads don\u2019t shift at all. Very solid and tight in there!

I thought I had a bleed/bore issue because my hydro wouldn't lock up under full force, turns out the stock style break pads were not sufficient to lock it up (even though stock pads work to lock rear wheels on foot brake). I switched over to Hawk HP+ pads and that did the trick for me.

I just did brakes with: Powerstop Evolution Sport, Drilled/Slotted Discs, Carbon-Fiber Ceramic Pad Part Kit#: P15K5305, Mach V Techna-Fit SS Lines, Motul DOT 4 fluid. All for under $600 and I’ve been very happy with this setup. I don’t track but drive spirited and they’ve performed flawlessly, and no more brake dust.

I put the Geomet coated Powerstop rotor and ceramic pad front and rear kits from RockAuto on my ‘14 XT. They work well and my speed demon wife liked them better than the originals.

I went with the powerstop z26, i think, carbon ceramic pads and drilled and slotted rotors all around for about 550 dollars from autozone. Fit and finish were perfect and did all four corners in my driveway in a couple of hours. The brake in procedure is very simple and they work very well. Zero brake vibrations and feels so much better.

I did the entire powerstop front and rear kit, has worked great, 0 issues in roughly 20k miles.

Running Hawk DTC 30s on a Mustang (3800 lbs with me) both front and rear. I brake hard and the car is heavy. The pads don't glaze nor fade. Wear is OK.

i have had powerstop on my car for the last year and a bit, no complaints, brakes are still good for dailying but with more bite when you jam down on the pedal

Hawk hp+ and a small car duster, they are dusty. You loose some initial bite but the more you dig in the better they work.

My wheel looked the same after an autocross day with my 2017 Mustang GT. I was daily driving these pads a couple years ago, and they nearly destroyed my wheel finish when I left the dust on too long (not to mention how incredibly noisy they were). It took multiple washes with iron remover and the wheels off the car to properly clean it all off.