Brake pads OEM Volvo or JURID

Had my pads changed (Volvo service centre) at 30k ish miles, at the main dealer and the discs were fine.

What bloody manufacturer is this? For my Volvo XC60 it’s around £330 for front discs and pads main dealer

The Jurid pads did work. They were 13.8mm that seems to be the key.

Who the hell told you the C30 is unreliable. My mechanic started his own shop after working for the big regional volvo dealership for 15 years. He told me that of all the Volvos he ever worked on the C30 stood out significantly as being the most reliable. It was built on the P2 chassis, but since it came out years after the first P2 chassis cars, it was able to have a lot of significant improvements/upgrades/fixes over the other, older P2 cars. He told me that over time the mechanics would get so frustrated whenever a C30 came in, because every single time all it would need was a basic oil change or brake pad replacement, never any major work.

Good braking, squeak free, low dust. The OE pads are great. They have good initial bite, no noise, high quality but they are semi-metallic so they make a bunch of dust. There are ceramic pad options that are low dust but they can be squeaky and won’t perform that great until they are warmed up. And of course you can get bargain bin organic pads which will have low dust but won’t perform nearly as well as stock. It’s a trade off no matter what. I went with the OE Jurid pads. I’d rather clean my wheels than lose braking performance or deal with noise. Also keep in mind that the rotors matter with noise and dust too.

Pal has Volvo brakes on his bmw E10.

My only problem with it is the turning radius. The brakes aren't what they should be IMO for triple digit speeds but it is rare I drove at such speed being located in the USA.

The pads were about 60% worn and hard large metal shards embedded in them and the rotors have always been badly grooved from day 1. This suggest that its more likely the rotor that is a soft material. Once there are metal shards in the pads that will cause uneven friction and promote brake grab and pulsing. I replaced the pads and the \u201cwarp\u201d pulsing has gone completely, but I suspect the new pads will also eventually pick up metal shards from the rotor. The other point is in case people want to avoid factory pads is that the front pads are Jurid and the rears ATE. I ve replaced all with Padid.

When I picked her up, I was told my front and rear brake pads are all down 1mm already. At this rate I’ll likely need to replace them around 15k. I thought this made sense for the front pads since they’re the JURID high performance ones, but the rears being worn that much seemed strange. I don’t drive fast/brake hard/etc, never track, or do anything otherwise that should wear my brakes prematurely.

Volkswagen uses Jurid and Pagid Black compound brakepads as OEM on our Passats. The problem is that these pads take a very long time to correctly bed into the brake rotors. If these pads aren't bed correctly, over time they will wear unevenly on the rotor which causes vibration. That vibration is what causes your brakes to squeal!!