Brake pads OEM Toyota or Hawk Performance

Hawk ER1. They’re fantastic.

I went with hawk 5.0 pads, they dust wayyyyy less than stock. Bite and stopping power feels just as good.

I run Hawk HP+ on the street, they do not seem to need heat to work. There is some dusting but little noise and they don't seem to eat through rotors.

I've been running the Hawk 5.0s on a bunch of cars. I like them, they've even held up to a couple track days. Lots of dust but I think that just comes with the territory of performance pads.

I was overheating mine and switched to Hawk HPS 5.0. I’ve only run them in the street so far but they fit that role fine.

I use Hawk 5.0 with centric 120’rotors. Minimal dust, no noise. Cold performance friendly but enough room in the temp range. So I can beat on it at auto X but still Street friendly.

I would post up in some E90-specific forums and see if you can get some feedback there, or at least piston measurements to compare to your stock brakes.Like others have said, the biggest thing you're looking for is to not effect your brake bias.All this said, don't let this hold you back from getting some more seat time. Throw in some fresh fluid, maybe get the HT-10s (which I've had good luck with on track personally), and get some more days under you before spending money on mods.

I have a 2015 Sequoia and I use Hawk LTS pads with Stop Tech Sport slotted rotors. A bit more $$ but it’s your brakes, it’s worth it.

Hawk 5.0 for street/autox. I like them but they do make a fair bit of dust and maybe a little underpowered for heavy track.

My wheel looked the same after an autocross day with my 2017 Mustang GT. I was daily driving these pads a couple years ago, and they nearly destroyed my wheel finish when I left the dust on too long (not to mention how incredibly noisy they were). It took multiple washes with iron remover and the wheels off the car to properly clean it all off.