I was hugely disappointed, because the pads are great. TBH, it's basically a low- to mid-tier race pad, so the price is not that ridiculous. I put quite a few track days on them and after trying out some other aftermarket pads, I actually went back to the OEM pads for 3-season street use.
The street type are great all rounders, reasonable bite and minimal drop off. Pretty low dust and noise, and wear was terrific. The set I had lasted longer than the oem pads I had before them. The performance of the track orientated pads is absolutely insane. The initial bite is like no other pad I've ever had. It drops off a tad but still great stopping power. However dust and noise are pretty terrible.
I run the Project Mu HC+ and DBA4000 rotors on a FK8 CTR that is also daily driven. over all very happy works ok when cold but 1 or 2 stops and its up to temp and has great bite. and really only minor pad sequel when stone cold.
The best solution I have found is to use slotted rotors--cryo treatment typically gets me 10K more miles before hard spots develop and I get a pedal vibration--and an aggressive pad without any ceramics. My solution is to use the best quality slotted rotor I can find, cryo treatment preferred, and use either a Wilwood BP-10/20 pad or a Project Mu NS brake pad. I found those two pads were aggressive enough to have great stopping power and would wear out the rotor at the same rate the pad wore down.
I personally use Project Mu HC+800 for their fantastic cold bite and high temp resistance.
I as well just replaced the oem brakes after almost 7 years. Other than a warrantied sensor, I've not had any issues. Still a blast to drive after 7 years, it still feels new.
The STi also stops hard. It turned in the shorter braking distance of the two cars, using just 114.5 feet of asphalt to haul down from 60 mph. Pedal feel is firm and progressive, and ABS operation is quiet and refined.
I had an 2017 Outback 2.5, had it since April of 2017 until last week, during that time I put on 93k km on it. I wish I had gotten the 3.6, I got the 2.5 hoping to save fuel, my average was around 25mpg for lifetime, and I drive a lot on hwy and country road, I never once was able to hit the 30mpg even if it's just me in the car and driving 50mph on the country road, this part I really feel like Subaru should correct their mpg reading, in winter it can get as bad as 18mpg in the freezing weather, as when it's cold the transmission will make the engine constantly rev at higher to warm it up, the 2.5 is also not a smooth engine when at idle, I had a vibration issue that was deemed normal. Overall, it's a reliable car, but its not a durable car, another thing is, when taking off quickly from a stop, it can really bog down, most people are used to first gear and just boot, but these CVT don't have first gear and it can be rather unexpected, I've almost got hit from behind a couple times from that. The eyesight is a good feature, the lane departure can be annoying at times but I was ok with it, these cars have an issue with windshield chipping, and if the car has eyesight, the windshield need to be a specific one and then the eyesight needs to be re-calibrated, this happened to me TWICE, and it got expensive very quick. OEM tires are lousy, by lousy I mean it doesn't even get good mpg, doesn't get good grip in ANY condition and puncture easily if you take it to any sort of gravel road, I had puncture the tire within 1200km, I just got some decent A/T tires after, no problem for the last 90k. The brakes are soft, so first thing I did was changed the pads.
The brake pads suck.
IMHO, the brakes are also awful.
Write your review
Help others - share your experience with this part.
