Brake pads OEM Porsche or DIXCEL

Dump the OEM pads. I went Dixcel in my M3 and the thing stops better and there’s so much less dust. Traded off is squeal at higher brake temps.

I have always ran DIXCEL Z on all my cars. Extremely quiet once you bed them in and has a temp range of 0-850°C with a friction coefficient of 0.67. They're just a bit dusty.

i had this same work done on mine after i brought her home last year. cost about the same (im in a HCOL area). did the air filters myself, saved a few bucks. but everything else: brakes, spark plugs, etc... 08's are a .1, if its yours, might as well add in a borescopes through the plugs for piece of mind!

Had the same issue with my 987.2 S, ended up upgrading to a GT3 master cylinder and brake ducts, giro disc rotors and RS29 pads. Obviously running decent brake fluid and change it regularly. It’s now great and can handle many laps of Oulton Park without fading.

My 981 Cayman is very maintenance friendly. I’ve done oil, transaxle oil, spark plugs (tight space but doable), brakes, etc. It is quite a bit easier than the 718 since you have to remove underpanels to gain access to the underside of engine/transaxle.

personally i run dixcel z-type pads and a stock rotor with DOT4 fluid and its one of the best upgrade options IMO

I had a 996.2 and an early 2.5L 986 and I loved the Boxster more. One of the best cars I've owned. I drove it back and forth from NC to WI several times. I am 6'5" and had luggage room to spare. It made better sounds than the 996. It was not very fast. It was pretty easy to work on and every single DIY job is well documented online. It was really comfortable. The handling is awesome, the brakes are awesome. Even the base ones.

These are the best double duty brake pad I have tested so far. I have tried stoptech 309 and EBC blue ndx which will start to fade around 4-5 laps at my local track. The dixcel pads I can not get them to fade at all. Pad life seems okay with mix use but street manners are abit worst than the stoptech and EBC (sometimes squeals and dust alot).

had a track day over the weekend and saw that a hard, black substance that seems a little rubbery had formed on the brakes. The brake pads are Dixcel ES brake pads. I had not bedded them in and instead street drove with it for a couple months as the website suggested. Brake grease was placed on the pad surface contacting caliper. The track has lots of left turns and I braked from 170+ kmh to 80kmh on the first corner. I'm pretty new so i may have braked deep as I was turning. The substance formed heavily on right front wheel, less on left front and none on rear. Brakes were smoking lightly when i came into the pits. Braking feel didn't change throughout the day as I continued lapping. Car still tracked straight. I tried not to brake too hard and didn't observe any other substance buildup.

Macan GTS’ are going through hell right now with PSCB brakes. Plenty of tickets just saying to replace the pads and rotors and customer to monitor lmao.