Brake pads OEM Mazda or DIXCEL

I inherited a 2011 cx7 from my parents who purchased this car new. They have always kept care of their vehicles. This is a non turbo model. Other than normal maintenance items they had replaced the AC compressor. Since I took it over in 2020, I replaced drive side front wheel bearing and passenger front caliper, brake pads all the way around plus normal maintenance items. 320,000km runs perfectly.

2016.5 CX-5 with 89,000 miles. So far I've had to replace the belt tensioner, accessories belt, water pump belt and breaks (technically I only needed pads and front rotors but I chose to just do them all in one shot since it made a negligible price difference since I was already doing the back pads.

Brakes - about to get them changed for the first time.

Dixcel m pads good stopping and ultra low dust.

At 55,XXX miles and still haven’t changed my brakes on 2019 AWD Mazda 3(not as heavy as yours but heavier than a FWD 3) Last service, I was in the green for both sets still, but they said I would likely be in “yellow” by 60-65k. I did want to note—I hear no scraping/squealing and brakes feel relatively strong just not as great as new.

2015 sedan. I did my brakes last spring. I went with OEM as I found them cheaper than any aftermarket I could find near me and as far as I knew I still had OEM on my car and had lasted me a long time. Zero issues since having them installed, I’m happy.

Seems a bit sus - but it's not unusual for rear pads to wear faster than front on certain cars. My Ford Flex and CX-50 both wear pads faster out back (it made sense on the Flex because of long wheelbase but was surprised the 50 did it too). That said they should last twice as long.

had a track day over the weekend and saw that a hard, black substance that seems a little rubbery had formed on the brakes. The brake pads are Dixcel ES brake pads. I had not bedded them in and instead street drove with it for a couple months as the website suggested. Brake grease was placed on the pad surface contacting caliper. The track has lots of left turns and I braked from 170+ kmh to 80kmh on the first corner. I'm pretty new so i may have braked deep as I was turning. The substance formed heavily on right front wheel, less on left front and none on rear. Brakes were smoking lightly when i came into the pits. Braking feel didn't change throughout the day as I continued lapping. Car still tracked straight. I tried not to brake too hard and didn't observe any other substance buildup.

easy 40 minute job to replace brakes on my 14 Mazda 3 took about two hours. It all pops off super easy going great. Go to put them on, well shit they don't fit. Try the other side for some reason thinking I'm just having a stupid moment. Doesn't work either.

Just had a dealer give me an estimate of $560 for new rear pads and rotors. Unfortunately, the idiot was going by mileage and he never actually looked to see that I just replaced the pads and rotors myself 10,000 miles ago. That was on my 2016 Mazda CX 5.