Brake pads Hawk Performance or OEM Audi

I use Hawk HPS 5.0 pads, happy with them so far

Hawk HP+ if you want to spend a little bit more and get an impressive bite force even when cold. Also suitable for street and light track duty.

I went with Hawk 5.0 pads and Zimmerman rotors on my 340i. Very happy with them.

I use Hawk 5.0 pads with R1 Concepts Drilled and Slotted rotors, stops on a dime and cuts alot of speed when adjusting going into corners very predictable

I run hawk 5.0 pads (i used to use ebc yellow but theres been reports of ebc pads delaminating so i stopped using ebc)

I use the centric premium coated blanks & change rotors every time I change pads.

For fluid I use ate200

I swapped out the hoses for braided ss hoses.

I currently use Hawk DTC60’s on my Scion FRS with Motul RBF600 fluid for track days. The brakes feel great to me, I like the bite, and they don’t fade even on multi day events.

Just switched to dba t2 w Hawk ceramics (combo set from new provisions racing) w factory calipers and lines.

I’d been considering brembo swap, but money had to be reallocated, so I abandoned full upgrade dreams. Old rotors were warped and pads were a dusty mess, so pretty much anything was an improvement.

Hawks are quiet, super-smooth/consistent engagement when I step on pedal, and minimal dust. Definitely happy w decision.

Motul RBF600 is a popular fluid choice.

pad choices are far and wide. i run hawk HP+ which isnt really the best track pad but its gotten me by. the paint on the back of the pads melted off before i ever felt fade so i guess they worked well but i suspect im *at* the limit of their performance.

Hawk hp+ and a small car duster, they are dusty. You loose some initial bite but the more you dig in the better they work.

Should’ve gone with EBC! Tried Hawk hps blues and could not go more than 500 miles before taking them off and replacing them with EBC yellows again. The noise was horrible.