Brake pads Ferodo or OEM Mazda

I’m using Brembo brake discs and Ferodo brake pads.

I bought a well maintained 2014 Mazda 3 hatchback with 60k miles two years ago for $8500. I’ve done rear and front brakes, as well as a rear wheel bearing in that time.

9 years working at Mazda and also a master tech, to me always oem fluid. No matter what, I for everything matter in fact. Seen lots of after makers stuff and even brake pads.

Just replaced acc drive belt, plugs and brake pads. One of the easiest cars to fix I've ever worked on. Overall, best car I've ever had.

Pads (Ferodo ds1.11 is what i started out with)

Mazda 6 Wagon Turbo Diesel.

I'm driving it into the ground ???? but loving every km I drive.

Brakes are the next job, I'm considering an upgrade to slotted rotors and better pads.

2024 prem plus with 50k miles and no major issues. At 6k miles the battery was defective and then at 11k miles and then again at 36k miles my front brakes were shot.

235 km/h on the german autobahn, from one border to the other, no issue! Except for the numerous heavy breaking... Going from over 200 to less than 100 several times in a row and you start loosing confidence in the brakes.

I purchased Ferodo DS2500 pads for autocross with the Brembos when my stock pads were shot. Lubed them up using CRC brake grease and even bought separate Girodisco backing plates to help with noise. It was absolutely terrible. Loud squealing all the time from 15mph to zero. Down hills, in traffic, or coming to a stop.

jai des ds2500 et mes freins sifflent tres fort cest chiant