Brake pads Ferodo or OEM Hyundai

I’ve ran the DS3.12... in my cayman. I get 15+ days on them... I like the harder bite from the Ferodos

Ferodo 2500 they are a (race pad) but work absolutely fine if you do daily driving I’ve had them for almost 6 months now and I’ve 4 track days along with daily driving and they have held up great

Ferodo ds 1.11 on my cayman GTS 4.0 seem to last a long time. 1 weekend at COTA which is very brake abusive plus another 3-4 weekends at a less brake intensive track. I drive them to/from the track and swap to ferodo ds2500 for street duty.

Ive been running the ferodo DS2500 and it seems to work well for occasional track use and mixed daily as well. Not too noisy on my older 911.

Right now I use Ferodo DS 3.12 on RE71RS tires. They are pretty high bite and take some getting used to. I might go a rung lower on the friction scale and go with DS 1.11 next time because of that. But the DS 3.12 are unfadeable and very consistent.

Ferodo DS2500 are a great compromise pad. They’re a bit more on the race side of things but I never had issues with them being sketchy. Just get a bit of heat into them early to make sure they’re there.

I'm going to tell you ferodo DS 1.11. Street driven on them a ton very easy on rotors. Endurance pad, much better than other things I see mentioned a lot like it blows my mind when people think RSL29s are better. I don't have an M3 but I have a 330ci which has the same brakes, and I've had lots of other cars from Corvettes to Mustangs and camaros. Have run that compound a ton.

I’m running DS2500 on my GTI and they are just not *quite* robust enough as I have progressed into the more advanced groups.

I switched to the Ferodo DSUno. I am satisfied with its performance, but they seem to struggle because of something. Today, after the track day on Saturday, I checked it and found a crack and a gnawed edge. Also, they have uneven wear, about 0.5-1mm difference. The differences are between the top and bottom parts of the pads, front and back parts and on different sides of the same rotor (inner and outer pads). Uneven wear was with the old pads as well. Recently, I installed brake air ducts, and after going out from the track, the temperature was, in the worst case, 480C degree, which looks fine for these pads. In total, I drove for about 3 hours on tracks, one on a wet track (so no hard braking) and two moderately/hard(8-9/10) braking. The brake rotors are also new, Zimmermann blank, installed with pads. The initial thickness of the pads is 16.4mm (with the plate, the plate is 5.5mm, so the "pure" pad is about 11mm) Currently, I have eaten about 4.5-5mm of the pads in 3 hours of tracking.

Late last year had the brakes completely fail on a 3 day old Pallisade and the dealer told the victims that yes it’s a known problem. No there’s not a fix, have a nice day and let them drive off in it. I basically begged them to pick anything else but they wouldn’t hear it, that is until they almost crashed with my two nephews in tow.