Brake pads Ferodo or OEM Chevrolet

I run DS3.12 now and ran DS1.11 on my previous car on track and love them (better then PFC-08)

My stock OEM pads are Ferodo DS2500 and I love them for daily and light track days.

Personally, I’m a fan of Ferodo, but I typically need to get them from the UK.

I was on the hunt for a facelift LT1 car and specifically went after a 95 for the stock bigger brakes and a few other things. I am extremely happy with my purchase and highly recommend.

The AP Racing kit was installed with a set of Ferodo DS2500s in the front and stock OEM pads installed fresh in the rear.

I did tons of research and settled on Ferodo DS3.12 (FCP4425G) in front and DS1.11 (FCP4697W) rear with Castrol SRF fluid. Stock R calipers and rotors have held up as well as any aftermarkets I read about for MUCH less $. Zero issues, and cheap.

I've had good results with Ferodo DS2500 pads. More torque than stock, dusting about the same.

Up for sale are new Ferodo DS2500 brake pads for an MK7 Golf R. I had bought these to replace my noisy new Hawk pads, but have decided to just stick with the noisy hawk pads.

SOLVED - I simply overheated the pads. Spoke to Ferodo and I followed their advice: Bed in was fine. Overheating led to pad material bake to the rotors. 120 grit block sanding on the rotors removed this. Pads were a little glazed but 80 grit sanding removed the shiny bits. Bed in again and running well but haven’t pushed it yet so unsure if the pads are done.

I hated Ferodo DS2500 on the street. Because they need to be warm to perform. And if I am driving on a highway for couple minutes or through a city, they loose the heat and perform badly for a bit.