Brake pads Ferodo or JURID

Been using these brake pads and shoes in my cars for the last 20 years with no issues

Buy pads and the sensor from FCP Euro. Use their lifetime replacement warranty for the next set. Went to the dealer in July for an alignment and they recommended pads for a similar price. I bought pads rotors and sensors for front and back, total was $1000 for BMW parts. You could save with Jurid which is listed as OE and OEM. My pads are at 4mm all around so I'm actually waiting for the sensor to trip before doing the job.

Very happy with the setup. I’ve failed to get it to fade on either mountain roads or the track, but never done long stints, maybe 20 min max. The DS2500s are nice because you can swap them out for other more or less aggressive Ferodo compounds without issue.

I ran Hawk pads on cars in the past and hated them, can’t say enough good things about the Ferodos.

I would recommend first to switch fluid for Castrol SRF then switch to Ferodo DS1.11 brake pads exclusively for track use and DS2500 for daily/canyon carving.The beauty of Ferodo brake pads is that it not needed to re-bedding your pads when switching compounds as long as you stay within the Ferodo family.DS1.11 are endurance pads that love to operate in very high temperatures which might not require cooling ducts.

Ether Motul RBF 600 or Endless RF650 brake fluid is a good options. As far as pads go Ferodo DS2500 is a great pad for street/track. It has relatively low dust and noise levels compared to other track pads, yet still has moderately high bite and solid fade resistance of a track pad.

I had a 172,Clio with ferodo DS2500 pads all round and brembo high carbon vented front discs and solid rear discs.

I run the Ferodo DS2500 which would probably meet your criteria. Fair warning though - they make noise, especially in the fixed Brembo calipers. You have to regrease them every few months.

DS2500s on my daily. Bit of squeak, but it’s not bad at all. I have EBC yellow on the rear as they don’t make DS2500s for a non PP mk7.5, and they’re garbage.

Previous discs and pads were OEM and the new ones are Ferodo. As mentioned previously, the sound was there with the OEM parts as well.

I put some Ferodo DS2500s for a HPDE event at the end of July and noticed discoloration and crumbling on the edges. Swapped them out with PFC08s for this weekend’s HPDE and noticed chunks of material missing from the inner of the pad.