I’ve had good luck with Power Stop brakes
I just swapped the pads for powerstops. It was around 170 for front and back. 20k miles later, still no vibrations.
Get you some Nitto NT555s, Caltracs traction bars, steeda lowering springs, GT500 swaybars, GT500 Fuel Pump, and a good set of brake rotors and pads from either Powerstop or EBC.
Powerstop Z23 pads/rotors. They squeal in the cold but they have great stopping power and no pulsations
P.S. I run more aggressive and dusty brake pads - EBC Yellow Stuff
Rear brake pads: Power Stop 17309
Since most pads won't even get that close to the edge, i wouldn't have thought twice about mounting it. Sure, i would check if it IS touching, but i really doubt it.
I've got Power Stop track day spec pads. They're a little noisy when cold and make a lot of dust but they still stop hard when cold and even better when they have some heat in them.
I have the powerstop z23 pads and man, they're so damn noisy. Anyone else experiencing the same? Trying to figure out if the shims need to be greased or the shop didn't put them on right ????
I’ve used powerstop and they’re no better than any cheap/ mid range brakes
Write your review
Help others - share your experience with this part.
