Brake pads EBC or OEM Mazda

I’ve had this exact set on a track day/daily driver…they will not fully bed in for like 300-500KM, trust me. After that, they feel like the hand of God stopping the car.

I've been more than happy with EBC Red Stuff pads - they hold up well to spirited mountain drives when I take my trips to AVF and Wookies each year, but have no downsides for daily driving duties. If tracking the car, you'll want something substantially more aggressive though.

Ran a kit of EBC brakes, green stuff i think on my old Mazda 6. Was a pretty decent upgrade over OEM and not much more expensive.

Another vote for EBC red. Have had them on my MK7.5 GTI and Porsche 991 C2S and very happy. Good initial bite and low dust as a bonus. Great for street but would consider Yellow if doing track days.

I used EBC yellow stuff. A little loud but great pads.

I did EBC red stuff and replaced pads all around at ~50k miles. My rotors weren't bad at all so I kept the old ones on. My pads coulda gone a few more years also. No complaints!

2016.5 CX-5 with 89,000 miles. So far I've had to replace the belt tensioner, accessories belt, water pump belt and breaks (technically I only needed pads and front rotors but I chose to just do them all in one shot since it made a negligible price difference since I was already doing the back pads.

i remember hearing a guy complain about his cx5 eating through brakes, but the cx5 is the same car as my mazda3, and my mazda3 has seen 70,000km for its rear brake pad/ 90,000km for the fronts, and I drive a mix of city/highway.

I bought and installed EBC red stuff pads on my stoptech slotted rotors. I also have stainless steel brake lines too. I've had several techs tell me my brakes are fine, but I literally can push the brake pedal to the floor in some cases, including the highway. It stays like that for a while too as I'll be driving at 60+ mph, go to stop and it has a long bit of travel. I will even pump up the brake pedal while at red lights and stop signs just to get some more bite but I feel like I might fuck up the master cylinder doing this enough. The fluid was flushed less than 6 months ago, but I feel like I need to switch to a better pad if this is actually the issue. I felt like my ABS wasn't even going off at one point due to these pads, or that I had some trapped air in my lines.

I put OEM Brakes on my ‘19 3 GT AWD. I’m 20K KM into them, and they pulse like mad when I brake above 90KM/h. Absolute fucking trash. The factory brakes also did this, above 90KM, but started around 50K into their life.