Brake pads EBC or OEM KIA

The inability to easily modulate light braking is the main reason I swapped in some EBC Redstuff pads. Very linear and better ultimate braking. You couldn't pay me to go back to the stock pads.

With EBC Yellowstuff Pads and Motul Fluid I was fade-free during multiple 25 minute sessions at my local 2.5 mile track. My front brake rotors read a temp of 650 degrees at the end of each session with ambient air temp of about 85 degrees.

Here's what I did at 30k miles as the originals had faded badly StopTech slotted rotor with EBC redstuff pad - I'm certain you'll get a thousand recommendations on better stuff. Love, love, love these brakes. Very little dust.

I went from OEM to ebc yellow stuff to combat brake fade on the track. I feel a bite difference on the road for sure. If you don’t mind a bit of squeak, the ebc brakes are good.

I also upgraded brakes to Optimal brand e-cote rotors and EBC Red street/performance pads. A nice improvement in brake feel and the new rotors look better, but hardly necessary.

Calipers cleaned up with new EBC pads, as well as a complete fluid flush.

Just had Stoptech slotted front rotors, EBC ceramic brake pads and Motul DOT 5.1 brake fluid installed on my 2016 GSW....BIG improvement at reasonable price....

I just had Stoptech slotted rotors & EBC ceramic brake pads installed in front along with Motul 5.1 brake fluid -- great improvement in stopping power at a reasonable cost

I switched to EBC redstuff ceramic from my OEM pads on my MX-5. They are marketed as slightly higher performance than OEM with much improved wear and dust levels. In my experience they are maybe slightly more grabby initially, otherwise they perform similarly to OEM, but their claims about dust levels were not true at all in my case, they dusted FAR more than OEM. I get noticeable dust after a few days compared to maybe a few weeks before.

We had really bad luck with EBC yellows, had a pad seperate from the backing plate, then the next set warped after one track day. Never again.