Brake pads EBC or Carbotech

They last me at least 3 days on brake-heavy tracks.

I switched to EBC Redstuff ceramics and am very happy. They’re quiet and the dust is light, and not brown. I think the performance is very comparable to OEM.

EBC redstuff. Very low dust. Similar feel to OEM pads but maybe slightly less initial bite.

Installed EBC Yellow Stuff pads for rear, kept original rotors, without even turning. 1000km later amazing so far.

I've been to 20 track events to this day I'm still running OEM calipers. Just carbotech pads. You don't need a big brake kit at all. The oem cracks because of improper cooldown. I learned that after a session to take my cooldown lap seriously and ever since then i stopped cracking AutoZone rotors

I ran stock rotors for a long time with carbotech xp10/8, front brake ducts, stainless lines, and Motul 660. The XP10/8 + ducts was sufficient for 20min session the tracks I drive.

Sometimes those alternatives work like K&N air filters or EBC brake pads for street use.

Those look a lot like EBC Greenstuff, I'm assuming a cheap copy - the EBC break-in coating on the front does work well and doesn't squeal but I work on the assumption that anything from Amazon is fake.

Ditch EBC. Discs are OK. But pads are just pure viral marketing via forums etc. Played havoc with the ABS on my GC8 Subaru when I had them (ABS kicking in actually massively increased stopping distances).

Took the Swift for a spirited drive down the horseshoe pass today, by the bottom the brakes stank, pedal went soft and stopping power became dangerously weak. Drove it softly for a mile or so and they were back to normal and I could lock the wheels again.