Brake pads Centric or OEM Mazda

I replaced all 4 sets of pads on mine with Centric ceramic pads from rockauto. They are quiet and set brake dust. They have excellent grip on the new rotors.

I like Centric’s Posi Quiet brake pads. A little more bite than original pads with substantially less brake dust.

At 55,XXX miles and still haven’t changed my brakes on 2019 AWD Mazda 3(not as heavy as yours but heavier than a FWD 3) Last service, I was in the green for both sets still, but they said I would likely be in “yellow” by 60-65k. I did want to note—I hear no scraping/squealing and brakes feel relatively strong just not as great as new.

Centric pads and rotors are pretty good. As said above Akenono is OE for pads, maybe rotors too. I run Akebono pads and Brembo standard rotors on my cars. Nice and clean and never any noise and I swear the standard brembo rotors stop harder the centrics drilled/slotted rotors.

2015 sedan. I did my brakes last spring. I went with OEM as I found them cheaper than any aftermarket I could find near me and as far as I knew I still had OEM on my car and had lasted me a long time. Zero issues since having them installed, I’m happy.

A few years ago I went with Centric Posi-Quiet Ceramic front pads - CENTRIC 10505690, currently $25.79 on RockAuto, and some Pagid front rotors from there. I know Pagid is a VW OEM and I have no reservations about their brake parts. I’ve run the posi-quiet pads on MK7 Golf and GTI and they’ve been fine.

I’ve used that combo on every car I’ve done brakes on and have had no issues. Great stopping power, very quiet, low dust.

Changed the pads front and rear was super easy and straight forward.Then after taking the car out of 'electric brake service mode' and starting the car I get the a yellow check engine light and code C05AB, clearing it made no difference. Only thing I could find online was "The electronically controlled brake unit detects that the pressure feed valve (primary side) is stuck ON (OPEN)."

Centric Posi-Quiet Ceramic... I didn't like them at first, until I bedded them in one early morning and ended up warming up to them.

Mazda brakes are notoriously shit. They’re garbage. Buy a set of PowerStop brakes and be done with it. They’re far superior to the Mazda brakes. Go on any forum and you’ll see countless people having the same issue as you. New brakes between 15-20,000 miles. Me included. I’ve owned 2 6s from new. Both needed brakes around 20,000 miles. Both times I put on PowerStops and never had another issue.